Great Planes Yak-54 3D Indoor EP ARF - GPMA1131 - Manual (Page 4)

4
ADDITIONAL ITEMS REQUIRED
Required Hardware and Accessories
This is a partial list of the hardware and accessories
required to finish the Yak 54.
Order numbers are provided
in parentheses:
Adhesives and Building Supplies
This is the list of Adhesives and Building Supplies that are
required to finish the Yak 54:
o Foam Safe CA+ Medium Glue 2oz (GPMR6070)
o 2 oz spray CA activator (GPMR6035)
o 8 oz Foam Safe Activator Refill 8oz (GPMR6036)
o Masking tape (TOPR8018)
o #1 Hobby knife (HCAR0105)
o #11 blades (5-pack, HCAR0211)
o Hobbico Soldering Iron 30 Watt (HCAR0775)
Optional Supplies and Tools
Here is a list of optional tools that will help you build
the Yak 54:
o Threadlocker thread locking cement (GPMR6060)
o CA applicator tips (HCAR3780)
o CA debonder (GPMR6039)
o Pliers with wire cutter (HCAR0630)
o Hobbico Duster ™ can of compressed air (HCAR5500)
o Precision Magnetic Prop Balancer (TOPQ5700)
o Hobbico Flexible 18" Ruler Stainless Steel
(HCAR0460)
o Hobbico Pin Vise 1/16 Collet w/6 Bits (HCAR0696)
o Great Planes Pro ™ CA Glue Thin 1oz (GPMR6002)
o X-Acto ® Extra Hands Double Clip (XACR4214)
IMPORTANT BUILDING NOTES
•
Self-tapping screws are designated by
a number and a length. For example,
#6 x 3/4" [19mm].
•
When you see the term test fit in the instructions,
it means that you should first position the part on the
assembly
without using any glue, then slightly modify
or custom fit the part as necessary for the best fit.
•
Whenever the term glue is written you should use foam
safe CA glue.
•
Photos and sketches are placed before the step they
refer to. Frequently you can study photos in following
steps to get another view of the same parts.
•
The stabilizer and wing incidences and motor thrust
angles have been factory-built into this model. However,
some technically-minded modelers may wish to check
these measurements anyway. To view this information
visit the web site at www.greatplanes.com and click on
“Technical Data.” Due to manufacturing tolerances which
will have little or no effect on the way your model will fly,
please expect slight deviations between your model and
the published values.
KIT INSPECTION
Before starting to build, take an inventory of this kit to
make sure it is complete, and inspect the parts to make
sure they are of acceptable quality. If any parts are missing
or are not of acceptable quality, or if you need assistance
with assembly, contact
Product Support. When reporting
defective or missing parts, use the part names exactly as
they are written in the Kit Contents list.
Great Planes Product Support:
3002 N Apollo Drive, Suite 1
Champaign, IL 61822
Telephone: (217) 398-8970, ext. 5
Fax: (217) 398-7721
E-mail: [email protected]