Great Planes Yak-54 3D Indoor EP ARF - GPMA1131 - Manual (Page 17)

17
o 5. Locate the landing gear. Remove the tape holding
them in place and thread them through the vertical
fuselage and into the horizontal fuselage. Be careful,
DO NOT press the landing gear all the way through the
horizontal fuselage. Glue the landing gear in place using
some foam-safe CA glue.
o 6. Use a hobby knife to remove the foam that sits behind
the center hole of the motor mount, so that it does not
interfere with the operation of the motor. Install the motor to
the motor mount using the screws provided with the motor,
or using the 3/8" x 5/64" [10 x 2mm] self tapping screws
provided with the Yak.
o 7. Place a small amount of the loop side of the self
adhesive hook and loop material to the back of the ESC and
receiver that will be used.
o 8. Place the hook portion of the self adhesive hook and
loop material on the Yak at the positions you wish to mount
the receiver, ESC, and battery. One example of where to
position the radio gear is shown above. These components
may be placed anywhere on the fuselage, as long as they do
not interfere with the action of the servos.
o 9. Install the propeller and propeller adaptor onto
the motor.