Great Planes Super Stearman EP ARF - GPMA1150 - Manual (Page 14)

14
Install the Motor Speed Control,
Receiver & Servos
If you have the bottom wing installed, remove it. This will
make the following installation easier.
❏
1. Included with your kit is self-adhesive Velcro ® . Cut it
into two equally sized pieces. Apply one half to the inside of
the fuselage as shown in the picture. Apply the other half to
the speed control.
❏
2. Install the speed control onto the Velcro ® you installed
inside the fuselage. The motor leads should be fed through
the front of the fuselage.
❏
3. Mount the motor to the fuselage with four 4-40 x 3/8"
[9.5mm] machine screws, #4 lock washers and #4 fl at washers.
Be sure to apply a couple of drops of thread locker to the
screws.