beautypg.com

Great Planes Super Stearman EP ARF - GPMA1150 User Manual

Page 12

background image

12

18. Included in the kit are two 15-3/4" [400mm] pushrod

wires with a Z-bend on one end. The wires most likely have
some glue residue on them from the masking tape that held
them together. Clean off any residue with lighter fl uid, alcohol,
etc. Install the end of the wire with the Z-bend into the outer
hole of both control horns.

19. Slide the wire into the hole on the side of the fuselage.

Test fi t the control horn into the slot in the elevator. When you

are satisfi ed with the fi t, securely glue the horn into the slot
in the elevator.

20. Repeat this for the rudder pushrod and control horn.

Install Landing Gear, Wheels,

Wheel Pants & Turtledeck

1. Mount the landing gear to the bottom of the fuselage.

Secure it to the fuselage with two 2-56 x 3/8" [9.5mm] machine

screws, #2 fl at washers and #2 lock washers. Be sure to apply
a couple drops of thread locker to each of the screws before
installing them into the fuselage.