Great Planes Super Stearman EP ARF - GPMA1150 - Manual (Page 11)

11
with the fi t, apply a couple of drops of oil to the wire where
it passes through the bearing. This will prevent any glue
from getting into the nylon bearing. Apply a small amount of
30-minute epoxy to both sides of the nylon bearing and into
the slot in the fuselage. Install the bearing into the slot. Wipe
away excess epoxy with a paper towel and alcohol.
Quickly
move on to the next step as it must be completed before
the epoxy on the tail wheel hardens.
❏
14. Test fi t the rudder to the rudder tail wheel wire and slide
the fi n into the slot in the fuselage. When satisfi ed with the fi t
remove the fi n and rudder. Apply a small amount of epoxy to
the uncovered portion of the fi n, into the slot in the fuselage
and to the tail wheel wire. Then, re-install the fi n and rudder.
Wipe any epoxy away with a paper towel and alcohol.
❏
15. Test fi t the tail wheel wire cone to the back of the
fuselage. Using the tail cone as a reference, cut away a small
amount of covering from the back of the fuselage to create a
wood gluing surface for the tail cone.
❏
16. Glue the tail cone in place to the back of the fuselage.
❏
17. Slide the tail wheel onto the tail wheel wire. Secure
it with the 1/8" [3mm] wheel collar and the 1/8" x 3/16" [3x
5mm] Phillips head screw.