Great Planes Extra 300S 1.20 ARF Patty Wagstaff - GPMA1305 - Manual (Page 26)

❏
17. Remove the wheel pants from the axle and wick
some thin CA into the holes you just drilled. Permanently
install the wheel pants and wheels in place using two #4 x
3/8" [9.5mm] sheet metal screws for the wheel pants and
the previously mentioned two #8 washers and one 3/16"
[4.8mm] wheel collars for each wheel.
❏
1. Connect all servos and servo extensions to your receiver.
Also, connect the on/off switch to the receiver. Wrap the
receiver in 1/4" [6.4mm] RC foam. Use a nylon tie strap to
hold the receiver in place as shown.
❏
2. Drill a small hole at the bottom of the fuselage and
route the receiver antenna to the rear of the airplane. Use a
rubber band to keep it stretched. Make sure you use a strain
relief inside the fuselage.
❏
3. Wrap your receiver battery with foam and use another
nylon tie strap to secure it to the servo tray.
❏
4. Install the receiver switch on the side of the airplane.
Make sure you do not install it in a place where it will
interfere with the wing. If you choose to install a rechargeable
jack, now is the time to do so. Make sure you use heat
shrink tubing or tape to secure all connections.
Finish the Radio Installation
26