Great Planes Phazer EDF ARF - GPMA1802 - Manual (Page 10)

10
❏
11. Bevel the edges around the balsa fi n hole cover, then
fi t and glue into position.
❏
12. Mount the bungee hook to the bottom of the fuselage
with a 3mm nut, washer and threadlocker on the threads.
ASSEMBLE THE WING
❏
1. Pull hard on both elevons to make sure the hinges and
the elevons are secure. If any hinges come out or seem loose,
add a few drops of thin CA to the hinge in the gap, allow to
harden, and then test again.
❏
2. Use a covering iron with a cover sock to go over the
wings and servo hatches and remove any wrinkles. When you
do fi nd wrinkles, fi rst glide the iron over the area to shrink the
wrinkle. Allow to cool for a second or two, then go back over
the spot, pressing down to bond the covering to the wood. If
the wrinkles won’t go away and just bubble up, reduce the
heat of your iron.
❏
3. Temporarily connect your servos, receiver, ESC and
battery and power them up with your transmitter.