Great Planes P-51 Mustang GP/EP ARF - GPMA1205 - Manual (Page 9)

9
❏
10. Temporarily place two landing gear door straps onto one
of the landing gear legs approximately 1-1/2" [38mm] apart.
Hold the gear door against the landing gear leg, leaving a
1/4" [6mm] gap between the door and the wing. Use a felt-tip
pen to mark the location of the strap holes onto the door. Drill
5/64" [2mm] holes through the door. Repeat this step for the
other wing panel.
❏
11. Cut the included piece of double-sided tape lengthwise
into two strips. Apply the tape to the landing gear legs on the
side that the gear doors will be installed. Install the gear doors
using 2x6mm phillips machine screws, 2mm fl at washers and
2mm nuts.
❏
12. Route the aileron servo leads through the holes in the
tops of the wing panels. Fit the air scoop into place onto the
wing panel with the anti-rotation pin as shown.
❏
13. Join the wing panels together on the aluminum wing tube.