beautypg.com

Finish the model – Great Planes P-51 Mustang GP/EP ARF - GPMA1205 User Manual

Page 16

background image

16

8. Test fi t your batteries onto the tray. Adjust the lengths of

the straps if necessary.

9. Trim the covering from the cool air exit hole on the

underside of the fuselage just behind the wing saddle.

FINISH THE MODEL

1. Make a strap from the included hook and loop material

to fi t your receiver. Cut a piece of foam rubber (not included)
to fi t your receiver and strap the receiver to the radio tray as

shown. Connect the rudder, elevator and throttle servos (or
ESC if applicable) to the receiver.

2. Mount your radio switch to the fuselage side in the

location that you prefer. We mounted ours below the aft bottom
edge of the battery hatch opening. We installed a charge jack
receptacle on the other side of the fuselage.

3. If you have installed a glow engine, install the removable

hatch by fi tting the two dowels into the holes in the fi rewall.

Then, slide the hatch back. Secure the hatch in place by

threading two 2.5x8mm self-tapping screws through the pre-
drilled holes in the fuselage and into the hatch.