Cisco XR 12000 Series - Manual (Page 48)

2-18
Cisco XR 12000 Series Router SIP and SPA Hardware Installation Guide
OL-17438-04
Chapter 2 Overview: Cisco XR 12000 Series Router Shared Port Adapters
2-Port Gigabit Ethernet SPA Overview
2-Port Gigabit Ethernet SPA (Version 2) LEDs
The 2-Port Gigabit Ethernet SPA (Version 2) has two types of LEDs: an A/L LED for each port (SFP and
RJ45) and a STATUS LED, as shown in
Figure 2-13 .
Figure 2-13 2-Port Gigabit Ethernet SPA (Version 2) Faceplate
Table 2-15 describes the 2-Port Gigabit Ethernet SPA (Version 2) LEDs.
The valid configuration of the SFP and RJ45 ports for the 2-Port Gigabit Ethernet SPA (Version 2) are
as follows:
• Port 0 (SFP) and Port 1 (SFP)
• Port 0 (SFP) and Port 1 (RJ45)
• Port 0 (RJ45) and Port 1 (SFP)
• Port 0 (RJ45) and Port 1 (RJ45)
or any single port
Note For Cisco XR 12000 Series Router, the RJ45 port is not supported on 2-Port Gigabit Ethernet SPA.
ST
ATUS
0 1
0 1
A/L A/L A/L A/L
SPA-2X1GE-V2
211969
2
1
1 A/L (Active/Link) LED 2 STATUS LED
Table 2-15 2-Port Gigabit Ethernet SPA (Version 2) LEDs
LED Label Color State Meaning
A/L Off Off Port is not enabled.
Green On Port is enabled by software and the link is up.
Amber On Port is enabled by software and the link is down.
STATUS Off Off SPA power is off.
Green On SPA is ready and operational.
Amber On SPA power is on and good, and SPA is being configured.