GME TX6500S User Manual

Page 24

2 4

I N S T R U C T I O N M A N UA L

T X 6 5 0 0 S

To SAVE a SelCall Ident to memory

1. Press the

key.

is displayed, along with the SelCall Ident that was last sent.

2. Press the

keys to select the Ident memory that you wish to programme (locations c0

to c9).

3. Enter the SelCall Ident as follows:

a. Hold the

key until a beep is heard. The right hand digit of the SelCall Ident will flash.

b. Press the

keys to select the required number in the flashing digit position.

c. Briefly press the

key again to select the next digit position.

d. Repeat steps (b) and (c) to enter all 5 digits as required.

e. Now press and hold the

key. The entire Ident will flash for a few seconds then the

radio will beep as the new Ident is stored.

To RECALL and SEND a SelCall Ident from the memory

1. Press the

key.

is displayed, along with the SelCall Ident that was last sent.

2. Press the

keys to select the Ident memory that you wish to recall (locations c0 to c9).

3. With the required SelCall memory displayed, press and hold the

key until the

icon

appears. The SelCall will be sent.

To RESEND the last RECEIVED SelCall Ident

1. Press and hold the

key until the

icon appears. The SelCall that was last received will

be sent.

To RESEND the last SENT Ident

1. Press the

key briefly.

is displayed, along with the SelCall Ident that was last sent.

2. Press and hold the

key until the

icon appears. The SelCall that was last sent will be

re-sent.

ADDING ALPHA NAMES TO SELCALL IDENTS

SelCall Idents stored in memory can be named using a 5 letter Alpha name. The name is stored into
memory with the SelCall Ident. If an incoming SelCall matches one of those in your radio’s memory, the
Alpha name can be displayed instead of the SelCall Ident.

Available characters

The following characters are available for use in naming your SelCall Idents.

PUNCTUATION

NUMBERS

LETTERS

– + \ SPACE

1 2 3 4 5 6 7 8 9 0

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z

Displaying Alpha names

To display the Alpha name of an incoming SelCall your radio must be in Alpha mode. To switch
between the Alpha mode and the Ident mode;
1. Briefly press the

key.

is displayed.

2. Briefly press the Squelch key to toggle between Ident and Alpha modes. A high beep indicates Ident

mode is selected (numbers are displayed) while a low beep means the Alpha mode is selected (text
is displayed).

Briefly press the

key again to exit or simply wait until the Call function times out.

45315-1_TX6500s_IM.indd 24

11/09/13 4:34 PM