GME TX3100DP - Manual (Page 18)

PA G E 1 8 I N S T R U C T I O N M A N UA L T X 3 1 0 0
Connecting the Microphone
The microphone uses a 6 pin plug and socket. To connect:
1. Position the microphone plug in the socket so the plastic tab
faces away from the speaker, and press the plug into the
socket until it ‘clicks’.
2. Gently slide the rubber boat towards the hole surrounding the
socket and press into place until it locks into the front panel.
Removing the Microphone
1. Slide the rubber boot back along the microphone cord.
2. Squeeze the plastic tab on the microphone plug towards the
plug to unlock it while gently pulling the plug outwards. If
the plug does not come out easily, the tab has not released
correctly and should be squeezed again.
Flipping the Display
The TX3100’s small size allows it to be mounted in almost any
convenient location. However the most suitable location may
sometimes require the unit to be installed upside-down when
referenced to your driving position.
The TX3100 is designed to overcome this situation by allowing
the display to be ‘flipped’. In addition the keys have symbols
that can be read from either direction.
You can flip the display as follows.
With the unit installed or held in the required orientation;
1. Turn the unit off.
2. Press and hold the key while turning the radio on.
3. The display will be flipped to match the radio’s orientation.
Cable
Screwdriver
Locking lever
move left to
release plug
Cable entry
hole
S
TX3100
Front Panel Upright (speaker above)
S
TX3100
Front Panel Flipped (speaker below)
Plastic tab
Speaker