GMC 2007 Acadia - Manual (Page 177)

The windshield wipers are controlled by turning
the band with the wiper symbol.
8 (Mist): Turn the band to mist for a single wiping
cycle. Hold it there until the wipers start. Then let
go. The wipers will stop after one wipe. Hold the
band on mist longer, for more wipe cycles.
9 (Off): To stop the wipers, move the band to off.
6
(Delay): The wiper speed can be set for a long
or short delay between wiping cycles. This can be
very useful in light rain or snow. Turn the band to
choose the delay time. The closer to the top of the
lever, the shorter the delay.
6 (Low Speed): Turn the band away from
you to the first solid band past the delay settings,
for steady wiping at low speed.
?
(High Speed): Turn the band further, to the
second solid band past the delay settings, for
high-speed wiping.
Windshield Washer
J (Washer Fluid): Press and release this
paddle, located at the top of the turn signal/
multifunction lever, to spray washer fluid on the
windshield. The wipers clear the windshield
and either stop or return to the preset speed.
The ignition key must be in ACCESSORY or
ON for this to work. See Windshield Washer
Fluid on page 420 Windshield Washer Fluid.
{ CAUTION:
In freezing weather, do not use your
washer until the windshield is warmed.
Otherwise the washer fluid can form ice
on the windshield, blocking your vision.
WASHER FLUID LOW ADD FLUID is displayed
on the Driver Information Center (DIC) when
the washer fluid is low. See DIC Warnings and
Messages on page 244.
177