Galaxy Audio TRAVELER AS-TV8 - Manual (Page 4)

AS-TVTX Audio Link Transmitter:
1. Remove the four panel mounting screws using a Phillips screwdriver. Remove the
existing panel from the bay opening as far as the attached wires will allow.
2. Look inside the bay opening and note the location of the 7-pin connector that
connects the wires from the main power switch to the main circuit board (See
Photo 5). Carefully remove this plug from the circuit board connector. Set aside
the removed panel.
3. Looking inside the bay opening, locate the 8-pin connector and wires emerging
from the left side of the main circuit board (See Photo 6). Leave the connector
attached at the circuit board but pull the free end of this wire group out of the bay
opening.
4. Plug this 8-pin wire connector into the connector at the rear of the TVTX module,
noting the alignment tabs. Make sure the plug is inserted all the way until the tabs
lock (See Photo 7).
5. Locate the wires and 7-pin connector coming from the main power switch on the
TVTX module. Plug this connector into the same 7-pin main circuit board
connector that was previously connected to the main power switch wires on the
removed panel (See Photo 6).
6. Looking inside the bay opening, locate the small switch on the top of the main
circuit board, near the rear edge (See Photo 6). Verify that this switch is in the
position labeled “Normal” (to the right.)
7. Locate the long black antenna wire that is attached to the TVTX module. Feed the
free end of this antenna wire into the bay opening and let it drop down over the
rear edge of the main circuit board (See Photo 8). Keep this antenna wire away
from the woofer cone area.
8. Carefully install the TVTX module panel into the bay opening, making sure not to
pinch any wires. Reinstall the four module panel mounting screws.
Photo 5.