Galaxy Audio CK-VBPR - Manual (Page 15)

D. Channel/Frequency Settings (with power on):
1. Press the + button to display a higher numbered channel.
2. Press the - button to display a lower numbered channel.
3. Press the set button to display the frequency.
E. Switch Off steps:
1. Turn the power/volume control completely counter clockwise until it clicks off.
F. Charging the AS-TVBPT and AS-TVBPR
1. These units have permanent rechargeable lithium batteries.
2. Plug the provided charger into the body pack and an AC power source when
the battery display shows empty.
3. An optional cradle charger that will charge two body packs at a time is
available.
Note: The word “Transmitter” in this procedure applies to either the AS-TVHH
Handheld, AS-TVH2 Handheld, AS-TVBPT Pendant, or the AS-TVMBP Body
Pack with its connected Microphone.
1. Make sure that both the Transmitter and AS-TVBPR Receiver power
switches are in the off position before beginning this procedure.
2. Receiver: Attach headphones to the Green headphone jack. Move the
power switch to the ON position. The LED indicator should illuminate
Red for a few seconds and then go out. If the LED lights up Green, first
double check that the Transmitter power switch is in the off position. If
the LED remains Green even when the Transmitter is switched OFF,
adjust the channel switch until the LED goes out. This will greatly
increase the likelihood that the Any Spot system will be functioning on a
frequency free from interference.
3. Transmitter: Adjust the channel switch to match the channel setting
selected on the AS-TVBPR. Move the Transmitter power switch to the
ON position. The Red low battery indicator on the Transmitter should
flash on and then go out. The LED on the AS-TVBPR should now
illuminate Green, indicating that it is receiving signal from the
Transmitter. If the LED on the AS-TVBPR does not turn Green, verify
that the Transmitter and AS-TVBPR have both been adjusted to the
same channel settings. If the AS-TVBPR LED still does not turn Green,
please try selecting a new group and channel on both the Transmitter
and AS-TVBPR to avoid any possible interference from outside RF
sources. Repeat this until the AS-TVBPR LED turns Green.
4. If using the AS-TVMBP Transmitter, verify that the switch on the back of
the body pack is set to "Mic". Increase the headphone volume control
on the AS-TVBPR slowly while speaking into the Microphone and
listening to the Headphones. If you are not hearing any audio or just a
low level signal, try increasing the Gain control (turn clockwise) on the
AS-TVMBP until a proper level is reached. If the audio sounds
13