FXpansion DCAM Synth Squad Quick Start Guide - Manual (Page 25)

25
1. Click the MIDI Learn button to enter MIDI Learn mode:
• the interface is ‘locked’ – controls cannot be manipulated
• all controls that can be MIDI-controlled are highlighted
3. Move the controller – for
example, the mod wheel.
Using MIDI Learn
DCAM: Synth Squad contains a built-in MIDI Learn system for mapping MIDI continuous controllers directly to
parameters. Here is a guide to assigning Strobe’s filter
Cutoff to a MIDI CC:
2. Click the control. 4. The MIDI CC is now assigned
to the control.
Click the MIDI Learn button again in order to exit MIDI Learn mode.
Note that the CC# can only be assigned to a single control. When you assign the modulation wheel to the
Cutoff, the original mod wheel assignment (to Perf.1) is lost.
Changes to the MIDI Learn assignments are persisted for the current session (but are not saved with presets!).
To save the assignments for future use, you must use the
Save as Defaults button in the Preferences panel.