FXpansion DCAM Synth Squad Quick Start Guide - Manual (Page 20)

20
Using DCAM: Synth Squad controls
Modulation in DCAM: Synth Squad: the TransMod system
Sliders are adjusted by
clicking and dragging
up/down.
• Sliders • Rotary pots
Rotary pots are adjusted
by clicking and dragging
up/down.
You can also double-click the control, type
a value and press ENTER or RETURN.
• Fine control over parameters
Hold down the SHIFT key while adjusting a control for finer resolution.
If you click on any of the 8 TransMod slots’ selection area (where it says ‘via’), or use the Prev/Next slot
buttons, the synth’s interface changes so that most of its controls are able to set and display modulation
depths away from the initial value.
In this example, Strobe’s first slot (assigned to key-on velocity) is selected, and contains modulation for the
osc
Saw waveform level, filter Cutoff and amp Level parameters.
• Selecting TransMod slots
TransMod
slots 1-8
Prev/Next
slot buttons
When you first launch a DCAM synth, it displays its Main view.
The Main view only edits the ‘basic state’ of the synth – the initial values of all controls before any TransMod
modulation.
.
• Main view