FXpansion DCAM Synth Squad Quick Start Guide - Manual (Page 42)

2
Using Animator as a note step-sequencer
1. Initialize Fusor and perform steps 1
and 2 of the ‘Using Animator as an
Arpeggiator’ tutorial.
2. Switch to the Animator page and click
on the Note Sequencer engine type.
5. Draw in a series of events on the Pitch Graph.
6. Do the same for the Velocity and Gate Graphs.
3. Choose ‘KeyMapper’ as the engine Destination.
The routing for MIDI input has now been set up as follows:
MIDI input
Animator engine 1 Key map Synths 1 & 2
4. Start the Fusor transport by clicking the
Start/Stop button in the Fusor LCD.
You must start your host transport if you’re
running Fusor as a plugin with the Sync
button enabled.