FXpansion DCAM Synth Squad Quick Start Guide - Manual (Page 21)

21
Using controls with a TransMod slot selected
Click outside the slider cap and drag
up/down.
The slider cap divides and the
modulation depth from the initial value
is set.
TransMod slot selected:
Setting modulation depth
Click the slider cap and drag
up/down to adjust its initial value,
or double-click to type a value and
press ENTER or RETURN.
TransMod slot selected:
Setting initial value
• Sliders
When modulation exists:
• Click/drag the initial part of the slider cap (without the arrow) to adjust it together with the mod depth.
• The other part of the slider cap (with the arrow) can be used to adjust the modulation depth.
• Hold down ALT and move the initial part of the slider cap (without the arrow) to adjust the initial value only.
TransMod slot selected:
Setting initial value
Click the centre of the
rotary pot and drag up/down to
adjust its initial value.
TransMod slot selected:
Setting modulation depth
Click and drag the outer ring
around the rotary pot to set the
modulation depth from the initial
value.
• Rotary pots
When modulation exists:
• Click/drag the centre of the control to adjust the initial value together with the modulation depth.
• Hold down ALT and move the centre of the control to adjust the initial value only.
2. Navigate through the sub-menus to the desired
modulation source.
1. Click on the top part of a TransMod slot to
display the source menu.
Scalers multiply the source, useful for scaling an LFO via the mod wheel, for example. They are selected in
the same way – click on the lower part of the slot to select it and display the scaler menu.
• Choosing TransMod slot sources and scalers
Upper: Click to select slot and show source menu
Middle: Click to select slot for editing
Lower: Click to select slot and show scaler menu
• TransMod slots