Future Retro Swynx - Manual (Page 16)

SYNCING
Connect the MIDI OUT of your master MIDI clock device to the MIDI IN
of the Swynx.
Connect the MIDI, DIN SYNC, and Analog/CR-78 clock outputs to the
appropriate MIDI, DIN SYNC, and Analog/CR-78 clock inputs of each
device to be synced.
Make sure MIDI and DIN Sync devices to be synced are properly setup
to receive external clocks.
Since the Swynx does not provide a Start/Stop control for the CR-78, you
need to press the CR-78’s Start/Stop switch to cue up the sync
operation. You will need to do this every time before playback is started.
Start playback of the master MIDI clock device, and all devices syncing
to the Swynx should begin playback.
Before stopping playback of the master MIDI clock, press the CR -78’s
Start/Stop switch. This allows the CR-78 to stop and reset to its first step.