Step 1. installing the suspension, Step 2. installing the first fixture, Step 3. installing the remaining fixtures – Philips IS-F7000 User Manual
Page 3: Step 4. end of row, Is_f7000, Philips, Lightoliièr, Lighting systems
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
LIGHTOLIIÈR*
Lighting Systems
IS_F7000
Page 3 of 6
Instruction Sheet for Assembly and Installation of Pendant F7000
Step 1. Installing the Suspension
A. Install the suspension assemblies to the junction boxes. (Fig. 1)
B. Make sure to secure the green ground wire from SJT Cord.
C. The first suspension in each row should be from the power feed end set, which contains a male power cord and
an end cap. (Fig. 1)
D. Install the intermediate and end suspension assemblies to the ceiling structure support at 12", 24", 48" or 96"
as required by fixture length.
Step 2. Installing the First Fixture
A. Orient fixture so female plug in fixture faces the SJT cord male plug.
B. Insert the Hanging Clips from first and second suspension assemblies into the fixture.
Make sure
to push excess
cable into fixture. (Fig. 2)
C. Connect the SJT male cord plug into the first fixture female plug.
D. Push the end cap fiush with the fixture.
E. Tighten the set screws as joint. (Fig. 3) Be sure not to over-tighten.
F. Level fixture by pressing down on top of cable grippers and pushing or pulling on cables as required.
Step 3. Installing the Remaining Fixtures
A. Orient the next fixture's female plug so it faces the first fixture's male plug.
B. Insert the Hanging Clips from second and third suspension assemblies into
the second fixture. Make sure
to
push excess cable into fixture. (Fig. 2)
C. Push fixtures together. (Fig. 3)
D. Tighten down each of the set screws in both fixtures. (Fig. 3) Be sure not to over-tighten.
E. Level fixture by pressing down on top of cable grippers and pushing or pulling on cables as required.
F. Repeat step 3 as many times as required to complete row.
Step 4. End of Row
A. Push the end cap fiush with the last fixture in row.
B. Tighten the set screws on top. (Fig. 3) Be sure not to over-tighten.
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
Lightolier is a Philips group brand
PHILIPS