Philips VR302 - Manual (Page 19)

If the display shows another indication, e.g. ‘DAILY’ or ‘WKLY’,
press button SEL one or more times until the display shows
‘DATE’.
@ Press button 9RC.
The display will show, e.g.:
t7?,T73;l 1
START on. on date
START l_r^l l_l
_l
END Of l.l ll l-PROG-l
I I
i_ I'UU '"'""U I
Now enter the programme number of the TV channel from which
you wish to record.
Q Press button ®RC once more to complete the timer
programming.
The display will show, e.g.;
N 1 1 ■ 1 1 1 1 1 1 1 1
-TRANSMIT
START
on. on
L U'OU
n i.nn
VCR1
DATE
r~
1
END PROG
1
L I’UU 1
Please note:
You may now proceed with the programming of other
TIMER-blocks and then with transmitting them one by one, to the
video recorder.
О Transmit the data to the video recorder. To do this, aim the
remote control at the video recorder and press the button
O))). The recording details are now being transmitted to the
video recorder.
The video recorder display shows the symbol РЯД.
• If the transmission is accepted the video recorder display will
show, e.g.:
The programming sequence is concluded.
• If an error occurred while either programming on the remote
control or during the transmission, the indication ‘ERROR’ will
appear on the video recorder display.
Should this be the case then go back and check all the data you
have entered and transmit it again.
Programming a recording which takes place daily or weekly:
You may programme a recording which will take place daily or
weekly at step O, entering the date of the recording.
If you wish to repeat the recording at the same time every day:
• Programme the TlMER-block as usual introducing the
starting time and the ending time (steps
O
to ©).
• When entering the date of the recording press button SEL
until the indication ‘DAILY’ appears on the display:
• Now press the digit buttons 0-9 to enter the date, on which
the first recording is to be made.
•
Conclude the programming sequence as usual following
steps © to ©.
If you wish to repeat the recording on the same day and at the
se time every week:
• Programme the TlMER-block as usual introducing the
starting time and the ending time (steps ©to ©).
• When entering the date of the recording press button 0-9
until the indication ‘WKLY’ appears on the display:
• Press now the digit buttons 0-9 to enter the date, on which
the first recording is to be made.
• Conclude the programming sequence as usual following
steps © to ©.
Please note:
• If during the programming sequence a button is not pressed
for 1 minute, you have to start the programming of this
TlMER-block from the beginning again.
• The content of the TIMER-biocks remains stored in the
remote control. You may therefore recall any of the
TIMER-blocks to check it or correct it as and when you please.
How do I recall and transmit stored TIMER-blocks?
O Press button 9RC.
The TlMER-block you used last, will appear on the remote
control display. All its programming details will be displayed.
© Using buttons -|- or — you may recall the other
TIMER-blocks.
© By pressing button O))) you may now transmit all stored
TIMER-blocks one by one to the video recorder.
(§|) 15