Philips CDC926 - Manual (Page 17)

TROUBLESHOOTING @)
If a fault occurs, run through the points listed below before taking your changer for repair. If the fault remains, try to clear it by
switching the changer off and on again. If this also fails to help, consult your dealer or an Authorized Philips Cervice Center.
Under no circumstances shouid you repair the changer yourseif, as this wiii invaiidate the warranty!
SYMPTOM POSSIBLE CAUSE REMEDY
- Playback does not start or
interruption of playback occurs.
- The current CD has been loaded
upside down.
- No CD inserted.
- The current CD is badly scratched or
dirty.
- Moisture condensation on the lens.
• Reload the CD, label side up.
• Insert the CDs, label side up.
• Clean the CD with a soft, lint-free
cloth.
• Leave the CD changer in a warm
environment until the moisture
evaporates.
- Sound skips (at the same part). - The current CD is dirty. • Clean the CD with a soft, lint-free
cloth.
- The current CD skips tracks. - The CD is damaged or dirty. • Replace or clean the CD.
- Playback does not start from the
first track (of the current CD).
- PRG (program) or SHUFFLE
activated.
• Switch off SHUFFLE or clear
program.
- No sound or bad sound. - Loose or wrong connections.
- Strong magnetic fields near the CD
changer.
• Check connections.
• Find another place for the unit or
change connections.
- No sound or bad sound on
headphones (CDC 926 oniy).
- Level control set to - position.
- Headphones plug is dirty. • Set level control.
• Clean plug.
~ Volume is too low. - Sound level has been adjusted too
low with the -VOLUME + keys on
the remote control (CDC 926 oniy).
• Adjust sound level.
- Remote control does not function
(CDC 926 oniy).
- Batteries are empty. • Replace the batteries.
- Remote control commands are not
properly received (CDC 926 oniy).
- The distance between remote
control and CD changer is larger
than 10 metres.
• Use remote control receiver EM
2200/2201.
• Reduce the distance between
remote control and CD changer.
G>
C
LU
17