Philips CDC926 - Manual (Page 13)

PROGRAMMING ®
STORING A PROGRAM IPRG and 1 - 0 )
- By programming the changer, you can play up to 30 tracks in any required sequence.
- FULL lights up if you exceed the maximum of 30 tracks.
- NOT POSSIBLE lights up if you select a non-existent CD number.
- USE 0-9 lights up if you press or 12 while programming.
• In STOP mode, press PRG (program) 3to open the memory.
- SELECT DISC lights up and liiiiaaiiaAl starts flashing.
• Select the number of the first required CD using DISC SELECT 6 or DISC 6 (on the remote control - CDC926
onl^.
• Key in the required track numbers of the selected CD using the 1-0 digit buttons 2.
- Every track number you enter in this way will be included immediately in the program.
- The display always shows the number of tracks and the playing time of your program.
• If you wish to store tracks from another CD, you should first enter the number of the CD.
• Press PRG to quit the PROGRAM mode.
• Press PLAY/REPLAY 74 to play the program.
D)
c
LU
CHECKING THE PROGRAM (REVIEW)_________________
• Press REVIEW 9 prior to, during or after programmed play.
- HEYlights up and all CD and track numbers appear in the
programmed sequence on the display.
- Under TRACK TIME you will see the playing time of each
track.
TRACK TRACK Twe
•riD
NO PROG will light up if no track numbers have been stored.
With REVIEW you can proceed more rapidly to the next block
of information.
ERASING A TRACK FROM A PROGRAM (CLR)___________
• Press REVIEW 9 before or after programmed play (STOP
mode).
- All CD and track numbers appear in the programmed
sequence on the display.
• Press CLR (clear) 4 as soon as the number you wish to erase
appears.
- The number has now been erased.
- The display shows the remaining number of tracks and the
remaining programme time for a few seconds.
TRACK TOTAL
PLAYING THE PROGRAM (PLAY/REPLAY)________________
• Press PLAY/REPLAY 14.
- Playback starts with the first number of the program.
The EDIT 10, PRG Sand CLR 4and PEAK SEARCH 79 buttons
cannot be used during programmed play.
Searching for a particular passage is only possible within the
track being played.
ERASING A PROGRAM (STOP/CP, CLR or OPEN/CLOSE)
In PLAY mode:
• Press OPEN/CLOSE 7 or STOP/CP 13 (twice).
In STOP mode:
• Press OPEN/CLOSE 7, CLR 4 or STOP/CP 13
- The program has now been erased.
NO PROG will light up if no track numbers have yet been
stored and if you have not pressed REVIEW first before
cancelling.
13