Futaba GV-1 - Manual (Page 46)

REFERENCE
2P 2-position (switch)
3P 3-position (switch)
A
ACT Activate
AFR AFR function
ATV ATV function P42
AUX Spare channel.
B
B/FS Battery fail safe P44
B/FD B/FS position setting P44
C
CH Channel
CONTRAST Contrast adjustment
D
DATA Data input key P24
DC Direct current
Dir Direct mode P39
Disp Speed display function P35
E
-ERR- Data setting error display
F
FUNC Function selection key P24
G
Gov, GOV Governor
Governor Governor
GRt Rotor gear ratio P35
GV-1 Model No. of this governor
GvOf Governor off high point stick
position operation setting P38
H
High High point P45
I
Idle Idle point P45
INH Inhibits operation
K
KEYSW Edit key
L
LCD Liquid crystal display
Lmt Limit setting function P45
Low Batt Battery alarm
Glossary
The Glossary gives the definition and the number of the page that describes
the related function for the symbols used in this manual.
M
m.trim Mixture trim
Max
MAX speed display function P33
MD Mixture rate setting function P40
MG Mixture rate setting function P40
MIXTURE Fuel mixture
MSx Mixture servo reverse P42
MTm Mixture trim P43
MxMD Mixture servo operation mode
P39
MXTR Mixture
N
Norm Normal side
O
on on
off off
P
PCM Pulse code modulation
R
Rev Reverse side
RH Relative humidity
rpm, r.p.m. Speed (revolutions)
rS1,rS2,rS3 Speed setting position
RX Receiver
S
Sen Rotation sensor monitor P46
SENSOR Sensor
Stop Stop point P45
Stsw Governor on/off stick operation
setting
P37
SWCd Governor on/off condition P37
SWPt
Governor on/off switch position
setting
P36
SX Servo
T
THRO,THROTTLE Throttle
Tst Throttle servo operation test P46
Tx Transmitter
V
Volt Unit of voltage
VR Variable resistor