Futaba 10CG 2.4GHz User Manual
Page 85
85
Camber Mixing (CAMBER MIX)(GLID):
This function adjusts the mixing rate of camber operation which operates the
ZLQJ FDPEHU DLOHURQV DQG ÀDSV LQ WKH QHJDWLYH DQG SRVLWLYH GLUHFWLRQV 7KH
DLOHURQÀDSDQGHOHYDWRUUDWHVFDQDOVREHDGMXVWHGLQGHSHQGHQWO\DQGDWWLWXGH
changes caused by camber operation can be corrected.
Also the operation reference point of camber control can be offset. (PRE)
NOTE: Camber control is not assigned at default.
GOAL of EXAMPLE:
STEPS:
INPUTS:
Ex: Set the mixing amount for aileron
to 40%, camber control to VR(E),
reference point to desired point.
Open the CAMBER MIX function.
for 1 second.
(If BASIC,
again.)
C
to CAMBER MIX.
Choose desired slider.
C
to VR.
to VR(E).
Adjust the mixing amount for AILE.
(Ex: adjust to 40%.)
C
to AILE.
VR(E).
to 40%.
VR(E).
to 40%.
Set the reference point.
C
to PRE.
or
VR(E) to
desired point.
for one second.
Close menu.
Adjustability:
• Rate: -100% to +100%, with a default of +30%
• Reference point (PRE): The operation reference point of camber control can be offset. -100% to +100%, with a default of 0%.
START DELAY
(GLID 1A+1F only):
START DELAY
automatically switches the offset trims (OFFSET) from the START
condition's trims to the normal condition's trims after the delay time (max.10sec.).
This delay time set by the -dly- item when activating the START condition. (It is
convenient for hand launch glider.)
NOTE: The same delay amount for elevator and rudder is recommended when
using V-tail function.
Adjustability:
• Delay time (-dly-) range of 0 to 100%. The delay time is 10 second at 100%.
GOAL of EXAMPLE:
STEPS:
INPUTS:
Ex: delay time=5 second.
Open ADVANCE menu, then open START
DELAY
function.
for 1 second.
(If ADVANCE,
again.)
C
to START DELAY.
Activate the function.
C
to MIX.
to OFF or ON.
Set the delay time.
(Ex: 50% each surface)
C
to ELEV.
to 5O%.
C
to RUDD.
to 5O%.
Repeat as needed.
Close.