Futaba 10CG 2.4GHz User Manual

Page 32

MODEL NAME

: assigns a name to the current model memory. By giving each model a name that is immediately recognizable,

\RXFDQTXLFNO\VHOHFWWKHFRUUHFWPRGHODQGPLQLPL]HWKHFKDQFHRIÀ\LQJWKHZURQJPRGHOPHPRU\ZKLFKFRXOGOHDGWR
a crash.

Adjustability and values:
• Up to 10 characters long.
• Each character may be a letter, number, blank, or a symbol.
• The default names assigned by the factory are in MODEL-xxxx format

(MODEL-0001

IRU¿UVWPRGHOPHPRU\HWF

NOTE: When you COPY one model memory over another, everything is copied, including the model's name. Similarly, if
you change MODEL TYPE or do a MODEL RESET, the entire memory is reset, including MODEL NAME

6RWKH¿UVWWKLQJ\RXZLOO

want to do after you COPY a model, change its type, or start from scratch, is rename the new copy to avoid confusion.

GOAL of EXAMPLE:

STEPS:

INPUTS:

Name model 3 “Cap-232_” (where the
underline represents a blank space.)

Open MODEL submenu.

for 1 second.

(If ADVANCE,

again.)

to MODEL.

Confirm you are currently using the
proper model memory. (Ex: 3)

If SELECT does not indicate 3,

perform MODEL SELECT, p. 25.

G o t o N A M E a n d c h a n g e t h e f i r s t
character. (Ex: M to C)

to M

to C.

Choose the next character to change.

Repeat the prior steps to complete
naming the model.

to a

(note: lower case is available)

Repeat.

Close.

Where next?

Change the MODEL TYPE to glider or helicopter: see p. 34.
Change modulation [2.4G-10CH or 2.4G-7CH]: see p. 35.
Utilize servo REVERSE: see p. 38.
Adjust servo travel with END POINT: see p. 39.
6HWXSGXDOWULSOHUDWHVDQGH[SRQHQWLDOD/R,EXP): see p. 42.