Futaba 8SSHP - Manual (Page 36)

FACTORY REPAIR SERVICE
To insure prompt service, please follow the instructions given below.
1. Charge the batteries for at least 18 hours prior to shipment.
2. Return the system only. Not your complete installation. Remove the servos from their
mounts and remove the foam padding from the receiver.
3. Plugs or other modifications which interfere with factory test procedures will be relumed to
factory standard at your expense.
4. Carefully pack all components individually, using sufficient packing material to prevent
damage during shipment.
5. Include a brief but thorough explanation of all problems and service required and tape it to
the back of the transmitter Place a label describing the function of the servo on each servo.
6. Be sure to include your full address and tel. No.. zip code inside the box as well as on the
outside.
7. Include a packing list of all items being returned, and double check to make sure that all
items are packed.
8. Upon receipt of your equipment al the Futaba factory, an estimate of the cost of repair
(over $25 00 only) will be sent to you- Your equipment will then be repaired and returned
to you upon receipt of payment or C O.D. (cash),
This factory repair service applies only 10 the continental U.S.A., Hawaii, and
.