Receiver, servo switch, and battery connections, Pcm receiver fp-r118gp – Futaba 8SSHP User Manual

Page 24

PCM RECEIVER FP-R118GP

• System checking can be performed with this lamp.

•When the receiver and servo side Nicd is connect-

ed and this LED is on, radiowaves are not being

received from the transmitter, check to be sure
the frequency is correct. Checking is possible by
the lamp being on.

•When strong noise has been received, or the

radiowaves from the transmitter are intermit-
tently interrupted, this lamp will blink.

This usually is not a problem.

Remove the receiver crystal by

pulling it in this direction.

Receiver crystal

Receiver, servo switch, and battery

connections

AEC-3

Extension cord

PCM receiver
FP R118GP

Power switch

SWH-5 (R4-SWJ)

Charging connector

NR-4J

Fig. 59

Pay careful attention to the

connector polarity.

Fig. 58

Error lamp

Crystal

Fig. 56

Antenna wire

Antenna

wire