Flintec FAA-25 User Manual
Page 2
FAA-25 Technical Manual, Rev. 2.08 January 2012
Page 2 of 10
WARNING !
The Error LED can be active before calibration. Do not care the error status before
performing the calibration of your weighing system.
Table of Contents:
1.
Features .......................................................................................................................................................... 3
1.1.
Technical Specification ........................................................................................................................... 3
1.2.
Housing Dimensions .............................................................................................................................. 3
1.3.
Model Identification ........................................................................ Fehler! Textmarke nicht definiert.
2.
Installation and Commissioning ...................................................................................................................... 4
2.1.
Mechanical Installation ........................................................................................................................... 4
2.2.
Electrical Connections ............................................................................................................................ 4
2.3.
Load Cell Connection ............................................................................................................................. 5
2.4.
Analogue Output Connection ................................................................................................................. 5
2.5.
Optional Digital Inputs / Outputs ............................................................................................................ 5
2.6.
Optional RS232C Serial Interface .......................................................................................................... 5
2.7.
Commissioning ....................................................................................................................................... 5
3.
Operation ........................................................................................................................................................ 6
4.
Setup and Calibration by using the Key Buttons ............................................................................................ 6
4.1.
Setup of the Analogue Output Mode ...................................................................................................... 6
4.2.
Setup and Calibration ............................................................................................................................. 6
4.2.1.
Entering Setup & Calibration ............................................................................................................................. 7
4.2.2.
Setup & Calibration ........................................................................................................................................... 7
4.2.3.
Exit from Setup & Calibration ............................................................................................................................ 7
5.
Setup and Calibration via Serial Interface ...................................................................................................... 8
6.
Troubleshooting .............................................................................................................................................. 8
7.
Declaration of Conformity ............................................................................................................................... 9
PRECAUTIONS
DONT LET UNAUTHORIZED PEOPLE INTERFERE WITH THE INSTRUMENT.
CHECK THE SUPPLY VOLTAGE, THE LOAD CELL AND ESPECIALLY THE
GROUND CONNECTIONS BEFORE ENERGISING FAA-25.
DON’T ENERGISE FAA-25 BEFORE MAKING THE LOAD CELL CONNECTION.
DON’T CONNECT / DISCONNECT THE CABLES AND/OR CONNECTORS WHILE
FAA-25 IS ENERGISED.
DO NOT OPEN THE ENCLOSURE WHILE FAA-25 IS CONNECTED TO THE
POWER SUPPLY.