Coleman 639C700 - Manual (Page 2)

Always fill outdoors. Never fill lantern, loosen or
remove fuel cap while lantern is lighted, near flame
(including pilot lights), other ignition sources, or while
top of lantern is hot to touch.
1. Turn FUEL VALVE to “OFF”. (Fig. 1)
2. Close PUMP KNOB firmly. Turn in direction of
arrow. (Fig. 2)
3. Remove FUEL CAP. Use a Coleman
® filter funnel
and fill with clean, fresh fuel. Lantern must be in a
level position. DO NOT TIP. (Fig. 3)
4. Replace FUEL CAP on lantern and on fuel
container. Tighten firmly. WIPE UP ANY SPILLED
FUEL AND DISPOSE OF IN A SAFE PLACE.
1. Turn FUEL VALVE to “OFF”. Light will
dim and go out in about 1-2 minutes. 1. Be sure FUEL VALVE is “Off” and fuel cap is
closed firmly.
2. Open PUMP KNOB one turn.
3. With thumb over hole in PUMP KNOB, pump
approximately 30 strokes. If lantern is not full of
fuel, more pump strokes are required. GOOD
AIR PRESSURE IS IMPORTANT.
4. Close PUMP KNOB firmly.