Fawcett TM Upper - Hyd. Driven User Manual
Page 3

FAWCETT, Inc.
LS manual
4/18/2007
page 3 of 7
Safety
Please follow the below safety precautions. If there are 
any questions, please call FAWCETT at 330 659-4187. 
Please read this complete manual before trying to operate 
your mixer. Failure to follow these instructions could result 
in serious bodily injury or death. 
• Do not touch moving parts while mixer is operating. 
Do not wear loose-fitting clothes or jewelry around an 
operating mixer. Keep all hands, feet, clothes, neckties, 
necklaces and other objects clear of moving parts. 
• Never move the unit with the motor running. 
• Have a qualified individual bring air to your unit. 
• Never run the unit in open air. 
• Never adjust the speed without the unit running. 
 
Air Motor Safety: 
The air motor is designed to be driven by compressed air 
and under no circumstances be driven with any other 
gases. Fluids, particles, solids or any substance mixed 
with air, particularly combustible substances likely to 
cause explosions, must not drive air motor. 
• Air motor is designed for air only. Do not allow corrosive 
 gases or particulate material to enter motor. Water vapor, 
 oil-based contaminants, or other liquids must be filtered 
 out. 
• Do not use a hammer or force coupling onto shaft when 
 installing drive onto air motor. This causes end thrust that 
 could damage air motor. 
• Ambient temperature should not exceed 200°F. 
• Beware of any exposed and/or movable parts to prevent 
 personal and/or property damage. 
• Solid or liquid material exiting unit can cause eye or skin 
 damage. Keep away from air stream. 
• Always disconnect air supply before servicing. 
• Do not allow air motor to “run free” at high speeds with 
 no loads. Excessive internal heat build-up, loss of 
 internal clearances and rapid motor damage will result. 
• Some models may exceed 85dB (A) sound level. 
 Hearing protection should be worn when in close 
 proximity to these models. 
 
Receiving
Before removing any packing, visually inspect the exterior 
of the shipment for any sign of damage. Should there be 
any damage, bring it to the attention of the delivering UPS 
or truck line and note the same on the receiving ticket. 
Should there be damage you must place a claim with the 
truck line. They are the only ones who will pay for the 
damage done and you are the only one who can place 
that claim. 
 
 
 
 
 
 
 
