Clarion VRX653R - Manual (Page 13)

VRX653R
15
English
Owner
’s manual
8. OPERATIONS
Basic Operations
Note: Be sure to read this chapter referring to the front diagrams of
chapter “3. CONTROLS” on page 5 (unfold).
CAUTION
When the unit is turned on, starting and
stopping the engine with its volume raised to
the maximum level may harm your hearings.
Be careful about adjusting the volume.
Note:
• Use this unit after starting the engine.
Turning on and off the power
Note:
• Be careful about using this unit for a long time
without running the engine. If you drain the car’s
battery too far, you may not be able to start the
engine and this can reduce the service life of the
battery.
1. Press the POWER button 1.
2. The illumination and display on the unit light
up. The unit automatically remembers its
last operation mode and will automatically
switch to display that mode.
3. Press and hold the POWER button 1 for 1
second or longer to turn off the power for the
unit.
Note:
• About the “SYSTEM CHECK”
The confirmation of connected equipment must be
performed for this unit only when the wiring
connection is complete and power is turned on to
the unit first. When the power is supplied, “SYSTEM
” and “PUSH PWR” appear alternately in the
display. Press the POWER button 1, the system
check starts inside the unit. When “COMPLETE”
appears, press once again the POWER button 1.
Selecting a mode
1. Press the FNC button 1 to change the
mode of operation.
2. Each time you press the FNC button 1, the
mode of operation changes in the following
order:
Radio mode
➜ DAB mode ➜ CD changer
mode
➜ DVD changer mode ➜ TV mode ➜
Radio mode...
∗ External equipment not connected with
CeNET is not selected.
Adjusting the volume
Operate the VOLUME button 2 in the direction
of the arrows
w w w w w (up) or z z z z z (down) to adjust
the volume;
w w w w w: Increases the volume.
z
z z z z: Decreases the volume.
∗ The volume level indicated in the display is in a
range from 0 (minimum) to 33 (maximum).
CAUTION
While driving, keep the volume at a level at
which external sounds can be heard.
Switching the display
When the panel is closed:
Press the DISP button @ to select the desired
display.
Each time you press the DISP button @, the
display switches in the following order:
Notes:
• Once selected, the preferred display becomes
the default display. When a function adjustment
such as volume is made, the display
momentarily switches to that function’s display,
then returns back to the preferred display
several seconds after the adjustment.