EDCO SS-26E - Manual (Page 8)

E-SS2636-DGE-I-1012
Printed in USA
©2012 TVW
Page 8
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com • Email: [email protected]
Figure 7
Before Starting the Engine/Motor:
• Read Rx for Concrete Saws before operating.
• Inspect machine before each use according to the Maintenance Schedule on page 15.
• Locate and be familiar with all engine and saw controls (Figures 2 ,3,4, 5 & 5A).
• Inspect the blades carefully before installing and then again several times during the
day. Use the correct blade for the job. Check rated RPM, diameter and size confi gura-
tion. Make sure blade is correctly mounted. (See page 14)
•
For wet cutting, attach supply hose to Water Hook Up Valve.
NOTE: Do not fl ip Blade Saver switch (Figure 6) to WET CUT until water pressure has
been applied and the engine has been started. This does not apply to SS26-E.
•
Adjust the handles for operator comfort and safe operation. Be sure to retighten knobs
once handles are positioned.
•
Scribe a line to help guide the saw, then position the saw over the scribed line.
Starting the Saw Gasoline:
• Verify the Drive Control lever is in the Neutral (center) position. (Figures 2 & 3)
• Verify that the blade is raised high enough to clear the ground.
• Disengage the Clutch. (Figure 7)
• Open the Throttle approximately 1/4, then follow the engine manufacturers Operating
Instructions for starting the engine. Allow the engine to warm up for about one minute
before beginning any cutting. Use the Throttle to adjust the engine speed. Turn the
Throttle handle counterclockwise to unlock, pull out to increase engine RPM, and turn
handle clockwise until tight to lock the throttle. Cutting should be done at FULL
THROTTLE. The engine governor is factory set - Do Not Change.
•
Use the choke to aid in cold weather starting. Pull the choke to activate. Once the
engine has started and is running smoothly, push the choke in to return to the operating
position.
Starting the Saw Diesel:
• Verify the Drive Control lever is in the Neutral (center) position. (Figures 4 &5)
• Verify that the blade is raised high enough to clear the ground.
• Disengage the Clutch. (Figure 7)
• Follow the engine manufacturers Operating Instructions for starting the engine. Allow the engine to warm up for
about one minute before beginning any cutting. Use the Throttle to adjust the engine speed. Turn the Throttle
handle counterclockwise to unlock, pull out to increase engine RPM, and turn handle clockwise until tight to lock
the throttle. Cutting should be done at FULL THROTTLE. The engine governor is factory set - Do Not Change.
Do not operate gasoline or diesel powered equipment without adequate
ventilation.
Carbon monoxide is an invisible, odorless gas that can kill.
Figure 6