Ecler CA‐NET RS‐232 - Manual (Page 5)

CA‐NET Protocol
page 5 / 29
ignored those exceeding this limit. Blank characters are not allowed. A valid example:
MAIN_HALL
 are text strings (without blank spaces) that identify the LCD display working
mode. In the CA200z there are just three possible values for this parameter:
o ON
o DIMMED
o OFF
 are numerical values in the [0…100] range that define the LCD display
contrast level.
 are text strings (without blank spaces) that identify the Talkover / Pager
function assignment for a MIC input towards the device’s outputs. In the CA200z there are
just five possible values for this parameter:
o OFF
o ZA
o ZB
o ZA‐B
o PAGER

is a numerical value that defines the Talkover function priority of one MIC input in
front of the other inputs in the unit. In the case of the CA200z just two values are valid [1,
2], being “1” the highest priority level and “2” the lower one.

is a numerical value for an error code.
 “” is a text chain inside double quotation marks, containing an error
description.
DAM514 NOTES:
 parameter
Originally designed to connect WPmVOL‐SR (or WPTOUCH) wall panels to the REMOTE ports
in the DAM514: panels that include a volume control knb and a 5‐position selector knob.
The possible working modes (
REMOTE_MODE command) of any of the 4 available remote
ports (R1 to R4) in the unit are:
o DISABLED
o IN_VOL: volume control for one or several inputs (general input volume, affecting all
the post processing)
o ZONE_VOL: volume control for one or several zone outputs
o IN_SEL: one input (source) selection for one or several output zones (with the 5
position selector)