Ecler DAM514 - Manual (Page 22)

22
9. SETUP MENU
The DAM514 features a general setup menu (hereinafter SETUP menu), or parameters that
globally affect the unit, such as the functions assigned to the REMOTE ports, the MUTE port
management, the LCD display management, etc.
To open the SETUP menu you have to simultaneously press and hold down the left and right
MENU keys.
The new edited values are activated in real time. You can cancel an edit operation, returning the
value before editing, by pressing SHIFT + CANCEL.
To exit the Edit menu and return to the main screen:
 Press SHIFT + EXIT
 Stay 2 minutes without operating any control on the front panel
The next page shows the full structure and options of the SETUP menu.
Notes:
1. Each of the REMOTE ports 1 to 4 can be connected to a WPmVOL-SR wall panel or similar,
which has two rotary controls: a 5-way selector (0, 1, 2, 3 and 4) and a volume control. Each
REMOTE port can be programmed to operate in one of the following modes:
 ALL DISABLED: REMOTE port disabled, no function
 IN VOLUME:
o The volume control acts on the overall volume of the inputs. It is necessary to use the
REMOTE INPUTS menu to determine the inputs that will be affected
o The selector is disabled
 ZONE VOLUME:
o The volume control acts on the overall volume of the outputs. It is necessary to use the
REMOTE OUTPUTS menu to determine the outputs that will be affected
o The selector is disabled
 IN SELECTOR:
o The selector acts as an input selector: it allows you to choose between OFF and up to a
maximum of 4 of the 5 available inputs, for the outputs to which it is assigned. It is
necessary to determine the inputs that will be part of the selection options (REMOTE
INPUTS menu) and the outputs that will be affected by the selection (REMOTE OUTPUTS
menu)
o The volume control is disabled
 IN SELECTOR+IN LEVEL:
o The selector acts as an input selector: it allows you to choose between OFF and up to a
maximum of 4 of the 5 available inputs, for the outputs to which it is assigned. It is
necessary to determine the inputs that will be part of the selection options (REMOTE
INPUTS menu) and the outputs that will be affected by the selection (REMOTE OUTPUTS
menu)
o The volume control acts on the volume of the crossing point between the input chosen with
the selector and each of the affected outputs (this allows the same input source to be
heard with a volume customized and independent for each output zone)
 IN SELECTOR+ZONE VOL:
o The selector acts as an input selector: it allows you to choose between OFF and up to a
maximum of 4 of the 5 available inputs, for the outputs to which it is assigned. It is
necessary to determine the inputs that will be part of the selection options (REMOTE
INPUTS menu) and the outputs that will be affected by the selection (REMOTE OUTPUTS
menu)
o The volume control acts on the overall volume of the outputs. It is necessary to use the
REMOTE OUTPUTS menu to determine the outputs that will be affected