Ecler CA200z - Manual (Page 15)

15
Note: In ZONES mode, the detailed LINE input adjustments are made independently for the
selected zone, A or B: a single LINE audio source can be adjusted with different volume and tone
controls for zones A or B. In STEREO, MONO and BRIDGE (single zone) modes, the detailed
adjustments are shared, given that there are no zones for independently directing and adjusting
the audio sources. During detailed adjustments of a LINE input, the affected zone is displayed in
the top left corner of the LCD screen (ZA or ZB).
Pressing and holding down one of the MIC keys accesses its detailed adjustments. The
complete process for entering and operating in this special adjustment mode, as well as the available
adjustment options, are shown in the following graphic:
Note: It is possible to exit the special adjustment mode (returning to the default mode) at any time
by briefly pressing any front panel key or waiting 20 seconds without working the controls.
Note: In ZONES mode, the detailed VOL adjustment of the MIC inputs are made independently
for the selected zone, A or B, and a single MIC audio source can be adjusted with different
volumes for zones A and B (but with the same BASS/TREBLE adjustments for both destination
VOL
Rotate knob
to adjust
level
Front knob SP: Short Press (press the front panel knob briefly, less than 0.5 seconds)
Front knob LP: Long Press (press & hold the front panel knob for more than 2.5 seconds)
LINEx VOLUME
Level: 0 to 64
LP to enter
the VOLUME
adjust mode LP
BASS
TREBLE
Front panel LINE sources setup
Level
shown in
LCD
To enter the LINE SETUP MODE, first select zone A or B with a tap of the front knob
or the IR remote (only when using the ZONES mode), then press LINE1 or LINE2 or
LINE3 or LINE 4 key and hold it for more than 2.5 seconds
SP
Press & hold LINEx key
to enter LINEx setup mode
LINEx setup mode
(x = 1, 2, 3 or 4)
Default mode (STEREO / MONO / BRIDGE / ZONE A or ZONE B)
SP to get
back
Rotate knob
to browse
options
SP SP to get
back
Level
shown in
LCD
LP
LP to enter
the BASS
adjust mode
LINEx BASS
Level: -10 to +10
Rotate knob
to adjust
level
Rotate knob
to browse
options
Rotate knob
to adjust
level
LINEx TREBLE
Level: -10 to +10
LP to enter
the TREBLE
adjust mode
LP
Level
shown in
LCD
SP to get
back
Rotate knob
to browse
options
LINE1, 2, 3 or 4
SP
SP