Ecler CA200z User Manual

Page 14

Notes:

1. The special adjustment mode can be exited at any time (returning to the default mode) by

briefly pressing any front panel key or not touching the controls for 20 seconds.

2. AUTOLOAD PRESET 1: when this function is active (ON) the CA200z will recover preset

no. 1 every time it starts up (using the ON/OFF switch on the rear panel or the power
supply).

3. REMOTE1/REMOTE2:

o When OFF mode is selected, the REMOTE port in question is disabled along

with its associated MUTE function, which is triggered by closing the external
contact connected to the MUTE port on the rear panel

When the VOL + INPUTS mode for a remote port is selected, it can manage the

remote volume in its associated zone (using a WPmVOL-type panel) or the
remote volume and the active LINE source selection in its associated zone
(using a WPmVOL-SR-type panel). The options on the panel are OFF, LINE1,
LINE2, LINE3, and LINE4, corresponding to the 5 physical positions of the dial
on the remote panel

When the VOL + PRESETS mode for a remote port is selected, it will be able to

manage the remote volume in its associated zone (using a WPmVOL-type
panel) or the remote volume and the CA200z's active preset selection, from 1 to
5 (using a WPmVOL-SR-type panel)

As only one of the two REMOTE ports can be configured in VOL + PRESETS

mode, the other will not display this option in the SETUP menu

See section 3.5 Remote control options for more details on remote management from the
REMOTE ports based on the operating mode selected on the CA200z (STEREO, BRIDGE,
MONO or ZONES)

4. When switching on the unit or recovering a given preset with any of the available methods

(starting up the equipment with the AUTOLOAD PRESET 1 option activated, using the
front panel, infrared remote control, RS-232 communication port, etc.), the physical
position of the dial on the wall panels connected to the REMOTE ports (if any) will be
bypassed if the CA200z's start up or new presets have source selection or presets
adjustments that differ from that physical position. As soon as the wall panel dial is used
again, the panels will synchronise with the CA200z unit, with the new selection prevailing

4.3. LINE 1 to LINE4, MIC1 and MIC2 front panel keys

A short press of one of the LINE or MIC keys activates/deactivates said audio source in

the previously-selected zone (see section 4.1 for selecting zones in ZONES mode). Only one (or
none) of the 4 LINE sources can be active in each output zone. It is possible, however, to activate
one or even both microphones (or none) in each output zone.

Press and hold one of the LINE keys to access its detailed adjustments (VOL, BASS,

TREBLE). The complete process for entering and operating in this special adjustment mode, as well
as the available adjustment options, are shown in the following graphic:

Note: It is possible to exit the special adjustment mode (returning to the default mode) at any time
by briefly pressing any front panel key or waiting 20 seconds without working the controls.