Dynaflite DYFA3030 - Manual (Page 17)

17
❏
2. Glue F2D to F2 with medium CA.
❏
3. Laminate the three F1 firewalls with 30-minute epoxy.
❏
4. Lay the 1/8" die-cut right fuselage side over the
plan. Mark the location of formers IP, F5, F5A, and F7
on the inside of the right fuse side. Place the left
fuselage side
above the right side as shown in the
photo and transfer the marks to the top of the left side.
NOTE: There are notches in the fuselage sides to
locate formers F2, F3, F4 and F6.
❏
5. Locate the two 1/8" x 1/2" x 42" balsa top
longerons . Glue one to the inside of the left fuse side
along the top edge beginning 3/8" back from the
front. Cut the longeron at the notch for the stabilizer
and glue the remainder of the 1/8" x 1/2" stick
along the stab cutout. Glue the other longeron to the
inside of right fuse side beginning 19/32" back
from the front.
❏
6. Glue the two 1/8" die-cut balsa wing saddle
doublers to the inside of the fuselage sides. Align
them with the wing saddle.
❏
7. Locate the two 1/8" x 1/2" x 24" balsa
bottom longerons . Glue one to the inside of the left
fuse side along the bottom edge, aligning it at the aft
edge of the wing saddle doubler. Glue the other to
the inside of the right fuse side.
❏
8. Glue formers F2 and F3 to the inside of the left
fuse side. Use a triangle to insure that the formers
are perpendicular to the fuse side.
❏
9. Fit the right fuse side to F2 and F3, sighting across
the top of both sides to align them. When satisfied with
the alignment, glue the right fuse side in place.