Dynaflite DYFA2018 - Manual (Page 4)

6-Minute Pro Epoxy (GPMR6045)
30-Minute Pro Epoxy (GPMR6047)
4 oz. Pro Wood Glue (GPMR6161)
Hand or Electric Drill
Sealing Iron (TOPR2100)
Hobby Saw
Hobby Knife (HCAR0105)
#11 Blades
Pliers (common and needle nose)
Screwdrivers (phillips)
T-pins(HCAQ5150)
60" RetractableTape Measure (HCAR0478)
Straightedge with scale
MaskingTape (TOPR8018)
Sandpaper (coarse, medium, fine grit)
Easy-Touch'" Bar Sander (or similar)
Plan Protector (GPMR6167)
Lightweight Balsa Filler such as Hobbico
HobbyLite'" (HCAR3400)
IsopropyI Rubbing Alcohol (70%)
Ballpoint Pen
90° Building Square
Heavy Sewing Thread (any color)
#64 Rubber Bands
Drill bits: 1/16", 5/64", 3/32", 3/16", 1/4"
OPTIONAL BUILDING OPTIONAL BUILDING
SUPPLIES
CAApplicatorTips (HCAR3780)
Epoxy Brushes (GPMR8060)
Epoxy Mixing Sticks (GPMR8055)
CA Debonder (GPMR6039)
Hot Sock" (TOPR2175)
Single-Edge Razor Blades (HCAR0312)
Heat Gun (TOPR2000)
Razor Plane (Master Airscrew®)
Great Planes Easy-Touch Bar Sanders are
made from lightweight extruded aluminum and
can be found at most hobby shops. They are
available in five sizes - 5-1/2" (GPMR6169) for
those tight, hard to reach spots; 11"
(GPMR6170) for most general purpose sanding;
and 22" (GPMR6172), 33" (GPMR6174) and 44"
(GPMR6176) for long surfaces such as wing
leading edges. Easy-Touch Adhesive-Backed
Sandpaper comes in 2" x 12' rolls of 80-grit
(GPMR6180), 150-grit (GPMR6183) and 220-grit
(GPMR6185) and an assortment of 5-1/2" long
strips (GPMR6189) for the short bar sander.The
adhesive-backed sandpaper is easy to apply
and remove from your sanding bar when it's
time for replacement.
This setup is all that is required for almost any
sanding task. Custom sanding blocks can be
made from balsa or hardwood blocks and
dowels for sanding difficult to reach spots.
•When you see the term "test fit" in the
instructions, it means you should first
position the part on the assembly without
using any glue and then slightly modify or
sand the part as necessary for the best fit.
4