Dynaflite DYFA2018 - Manual (Page 17)

Q 2. Use a flat blade screwdriver to knock out the
center of the second R1 ribs between the spars.
Q 3. Locate and glue the two die-cut 1/8" ply
center dihedral braces together using
medium CA or 6-minute epoxy.
Note: In preparation for the next step, protect
your work surface by covering it with waxed
paper or Plan Protector.
Q Q 28. Use a razor plane and medium (150-
grit) sandpaper to sand the leading edge to
shape. Use the die-cut LE gauges to check the
shape of the leading edge as you work. Sand
the tip section LE to match the die-cut 1/8" balsa
tip LE gauge, and the center-section LE to
match the die-cut 1/8" ply center LE gauge.
Q 29. Repeat steps 1 through 28 to buiid the left
wing panel.
Q 1. Remove the material from R1 between the
spars using a hobby knife.
Q 4. Test fit the center dihedral brace into each
wing panel. Make any adjustments necessary to
allow the wing panels to slide completely
17