Citizen Systems CBM-231 - Manual (Page 40)

CBM-230/231 User’s Manual
35 CITIZEN
(9) Specifying/canceling the underline (ESC – n)
Code: [1B]h + [2D]h + n
* {0
≤ n ≤ 02} The data is described with the hexadecimal code.
Specifying or cancels the underline.
• An underline is provided for the entire printed character width except a portion skipped by HT.
• The 90°- right-turned characters are not underlined.
• The following table lists the types of underlines deponing on the values an initial value is "1".
n (Hex) Type
0 Cancels an underline
1 Specifies a 1-dot width underline
2 Specifies a 2-dot-wide underline
(10) Specifying the 1/6 inch line feed rate (ESC 2)
Code : [1B]h + [32]h
Sets a line feed rate per line to 1/6 inch.
(11) Setting the line feed rate n/360 inch (ESC 3 n)
Code : [1B]h + [33]h + n
* {0
≤ n ≤ FF} The data is described with the hexadecimal code.
Sets a line feed rate per line to n/360 inch.
• The initial value is n = [3C]h
• Since an actual mechanical pitch is 1/203 inch, it is internally converted approximate to the value
specified with this command.
(12) Initializing the printer (ESC @)
Code : [1B]h + [40]h
Clears the data stored in the internal print buffer and initializes various settings (default).
• The data in the internal input buffer is not cleared.
• Reads in the DIP switches again.