Citizen Systems CBM-231 - Manual (Page 38)

CBM-230/231 User’s Manual
33 CITIZEN
(8) Specifying the bit Image (ESC * m n1 n2 D1 ~ Dn)
Code : [1B]h + [2A]h + m + n1 + n2 + Dn
* {m= Bit image mode (refer to the table below)}
{0
≤
n1
≤
FF}
{0
≤
n2
≤
02}
The data is described with the hexadecimal code.
Prints the data in the form of bit image in accodance with the bit image mode specified by "m".
•
The number of bit printed is divided by 256, and n2 and is assumed to be a quotient, and n1 to be the
remainder.
•
The total number of dots printed in the form of bit image is n1 + (256
×
n2).
•
When the bit image is entered beyond a 1 dot line (576 dots) position, the surplus data is discarded.
•
For the bit image data (Dn), the bit to be printed is set to "1" and that not to be printed to "0".
•
The following table shows the bit image mode.
( ) = For 42 columns spec.
Vertical Horizontal
m(Hex) Mode
No.of Dots Dot Density Dot Density Max. No. of Dots
0 8-dot single density 8 67 DPI 101 DPI 288 (252)
1 8-dot double density 8 67 DPI 203 DPI 576 (504)
20 24-dot single density 24 203 DPI 101 DPI 288 (252)
21 24-dot double density 24 203 DPI 203 DPI 576 (504)
•
When the value set for "m (bit image mode)" dose not meet the condition, the data subsequent to n1 is
processed as printing data.