D.A.S. Audio SLA Series - Manual (Page 24)

8
APPENDIX A. Bridge Mode Operation
To operate in bridge mode, follow these steps:
1. Switch off the amplifier.
2. Turn volume control potentiometers on the front panel to minimum position (fully anticlockwise).
3. Connect input signal to channel A.
4. Set mode switch to
5. Connect speakers as follows:
Connect (+) to red speaker terminal on channel A’s output terminals.
Connect (-) to red speaker terminal on channel B’s output terminals.
6. Turn volume control potentiometers on the front panel to maximum position (fully clockwise).
7. Control volume levels from the mixer or pre-amp only.
NOTE: We do not recommend using bridge mode with loads lower than 4 ohms.
Bridge.
EN
Manual del Usuario / SLA / User’s Manual