Cymatic Audio LR-16 Manual - Manual (Page 6)

PRODUCT MANUAL PRODUCT MANUAL 11 10 DIRECT TO USB RECORDING DIRECT TO USB RECORDING
8. DIRECT TO USB RECORDING
8.1. Turn on the device
Connect the LR-16 to the power supply and turn it on. After the start-up screen you will see the
following screen:
8.2. Connect USB storage device
When a USB drive is attached to the front panel USB port, the attached drive is mounted and
then the LR-16 optimizes itself for reading and writing the drive. With large drives it may take
around half a minute to complete this process.
8.2.1. Device Details
After the optimization process is concluded the device details are displayed.
8.2.2. Wrong file system
The inserted drive needs to be formatted in the FAT32 format, in order to be suitable for Direct-
to-USB recording. If this is not the case, you are given the option to format the drive.
!
Please keep in mind that formatting the drive will erase all data currently residing on the drive.
Please see section “Format USB device”
8.2.3. Disk error
If the inserted drive is defective or not supported, the screen will show a “Disk Error”.
If this occurs, please remove the device and refer to section ‘USB Hard Drives vs. USB Flash
Drives’.