Crosman Z37 - Manual

Stinger R37
6mm BB Spring Rifle
OWNER’S MANUAL
READ ALL INSTRUCTIONS AND WARNINGS IN THIS MANUAL BEFORE USING THIS AIRSOFT GUN
Crosman Corporation
7629 Routes 5 & 20
Bloomfield, NY 14469
www.crosman.com
1-800-724-7486 R37B515
If you have any questions regarding your airsoft gun, please contact Crosman at 1-800-724-7486, 585-657-6161 or www.crosman.com.
READ AND UNDERSTAND THIS ENTIRE MANUAL BEFORE USING THIS AIRSOFT GUN. AND REMEMBER, THIS AIRSOFT GUN IS NOT A TOY. TREAT IT WITH THE SAME RESPECT
YOU WOULD A FIREARM.
THIS IS NOT A TOY. ADULT SUPERVISION REQUIRED. MISUSE OR CARELESS USE MAY CAUSE SERIOUS INJURY, ESPECIALLY TO
THE EYE. EYE PROTECTION MUST BE USED BY THE USER AND ANY PERSON WITHIN RANGE. MAY BE DANGEROUS UP TO 100 YARDS (91.44 METERS). READ
OWNER’S MANUAL BEFORE USING.
YOU AND OTHERS WITH YOU SHOULD ALWAYS WEAR SHOOTING GLASSES TO PROTECT YOUR EYES.
READ ALL INSTRUCTIONS BEFORE USING.
BUYER AND USER HAVE THE DUTY TO OBEY ALL LAWS ABOUT THE USE AND OWNERSHIP OF THIS AIRSOFT GUN.
DO NOT BRANDISH OR DISPLAY THIS AIRSOFT GUN IN PUBLIC – IT MAY CONFUSE PEOPLE AND MAY BE A CRIME. POLICE AND
OTHERS MAY THINK IT IS A FIREARM. DO NOT CHANGE THE COLORATION AND MARKINGS TO MAKE IT LOOK MORE LIKE A FIREARM. THAT IS DANGEROUS
AND MAY BE A CRIME.
THIS PRODUCT CONTAINS ONE OR MORE CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER AND BIRTH
DEFECTS (OR OTHER REPRODUCTIVE HARM).
1. Safety First
• ALWAYS treat the AIRSOFT GUN as though it is loaded and ready to fire.
• ALWAYS treat AIRSOFT GUNs with the same respect you would a firearm.
• ALWAYS store the AIRSOFT GUN unloaded.
• ALWAYS store the AIRSOFT GUN away from children.
• ALWAYS aim in a SAFE DIRECTION.
• ALWAYS keep the muzzle of the AIRSOFT GUN pointed in a SAFE DIRECTION.
• ALWAYS keep your finger off the trigger and out of the trigger guard until ready to shoot.
• ALWAYS keep the AIRSOFT GUN “ON SAFE” until you are ready to shoot (see section 3A).
• ALWAYS check to see if the AIRSOFT GUN is “ON SAFE” (see section 3A) and unloaded when receiving it from another person.
• ALWAYS have you and others wear shooting glasses to protect your eyes.
• ALWAYS wear shooting glasses over eye glasses if your prescription or reading glasses are not safety glasses.
• ALWAYS place the backstop in a location that will be safe should the backstop fail.
• ALWAYS check your backstop for wear before and after each use. All backstops are subject to wear and will eventually fail. Replace your backstop if
the surface is worn or damaged, or if a ricochet occurs.
• ALWAYS use the proper size BB in your AIRSOFT GUN. Check the markings on your AIRSOFT GUN to verify the BB size is 6mm.
• NEVER reuse ammunition.
• NEVER shoot at hard surfaces or at the surface of water. The BB may bounce off or ricochet and hit someone or something you had not intended
to hit.
• NEVER attempt to disassemble or tamper with your AIRSOFT GUN. Use an Authorized Service Station.
• Modifying the function of your AIRSOFT GUN in any way, may be unsafe and will void your warranty.
• NEVER point the AIRSOFT GUN at any person or at anything you do not intend to shoot.
2. learning the parts of your new airsoft gun
Learning the names of the parts of your AIRSOFT GUN will help you understand your owner’s manual.
A. Vertical Forearm Grip
B. Barrel
C. Muzzle
D. Charging Handle
E. Trigger
F. Trigger Guard
G. Stock
H. Safety (Fig. 2)
I. Sling Mounts
J. Magazine
K. Magazine
Release Button
L. Front Sight
M. Rear Sight
N. Stock Adjustment Lever
3. Operate the Safety
NEVER point the AIRSOFT GUN at anything you do not intend to shoot.
A. TO PUT THE AIRSOFT GUN “ON SAFE”.
1. Locate the safety on the left side of the airsoft gun.
2. Turn the safety lever to “SAFE” for “ON SAFE. (Fig 2A). The safety is not “ON SAFE” unless it is pointing to “SAFE”.
B. TO TAKE THE AIRSOFT GUN “OFF SAFE”
NOTE: This airsoft gun fires in semi-auto mode. Semi- auto means you will have to pull the trigger each time you want to fire a shot.
1. Locate the safety on the left side of the receiver. (Fig. 2a)
2. Turn the lever to “FIRE” (Fig. 2b/ Fig. 2c)
3. The airsoft gun is “OFF SAFE” and ready to fire when pointing to either “FIRE.”
4. ADJUSTING THE STOCK
1. Your airsoft gun is shipped with the stock in the closed position and can be adjusted to different lengths.
2. Before adjusting the stock make sure your airsoft gun is “ON SAFE”, (see section 3A) and pointed in a
SAFE DIRECTION.
3. Push the Stock Release Lever and adjust the stock until it locks into the desired position.
5. Load and Unload AIRSOFT BBs
A. Loading the AIRSOFT GUN
1. Make sure the AIRSOFT GUN is “ON SAFE” (Section 3A) and pointed in a SAFE DIRECTION.
2. While supporting the BB magazine, push the Magazine Release Button and remove the magazine.
3. Open the magazine cap door (Fig. 4).
4. Insert 6 mm plastic BBs.
5. Close the magazine cap door.
6. Locate the BB guide on the front of the clip. Pull down and to the right until it locks into place. (Fig. 4)
7. Holding the clip horizontally as shown (Fig. 5) shake the clip until BBs feed into the magazine.
8. Release the BB guide by pushing the spring to the left and slowly releasing.
9. Insert the magazine into the airsoft gun making sure it clicks in place.
B. Unloading the AIRSOFT GUN
1. Make sure the AIRSOFT GUN is “ON SAFE” (Section 3A) and pointed in a SAFE DIRECTION.
2. Press the Magazine Release Button to release the magazine.
3. Open the magazine cap open.
4. Pour out BBs.
5. To release the BBs in the ready tube, point the clip down in a safe direction and push back and hold the BB
retainer button. Note , BBs will release rapidly.
6. Close the magazine cap.
7. Never assume that because the airsoft gun no longer fires a BB and/or the loading chamber is removed, that a BB is not lodged in the barrel.
WARNING: EVEN THOUGH YOU GO THROUGH THE UNLOADING PROCEDURE, CONTINUE TO TREAT THE AIRSOFT GUN AS THOUGH IT
WERE LOADED. DO NOT POINT AT ANYTHING YOU DO NOT INTEND TO SHOOT.W
6. MOUNTING OR REMOUNTING THE VERTICAL FOREARM GRIP
1. Loosen the knurled nob at the base of the grip by turning the nob counter-clockwise.
2. Gently slide the handle to the desired location on the forearm, then slowly tighten the mounting screw by turn-
ing the nob clockwise until the grip engages the rail.
7. Cocking your airsoft gun• Make sure the airsoft gun is “ON SAFE” (See Step 3).
1. Point the airsoft gun in a SAFE DIRECTION.
2. Make sure the magazine is loaded and installed in the gun. (Fig. 6)
3. Locate the cocking handle at the back of the airsoft gun.
4. Pull the handle back until it clicks.
5. Release the handle.
6. The airsoft gun is now cocked and ready to fire.
NOTE: You must cock the soft air gun before each and every shot.
8. AIM AND FIRE SAFELY
A. FIRING SAFELY
1. You and others with you should ALWAYS wear eye protection designed for airsoft to protect your eyes.
2. Always aim your AIRSOFT GUN in a SAFE DIRECTION.
3. Do not shoot at hard surfaces or at the surface of water. The plastic BBs may bounce off or ricochet and hit
someone or something you had not intended to hit.
4. DO NOT re-use plastic BBs because they could possibly cause damage to your AIRSOFT GUN.
5. Your AIRSOFT GUN is designed for target shooting and is suited for both indoor and outdoor use. Always remem-
ber to place your target carefully.
6. THINK about what you will hit if you miss the target.
7. Your AIRSOFT GUN is correctly aimed when the front sight blade is position exactly in the notch of the rear sight.
8. The top of the front sight blade should be even with the top of the notch in the rear sight. The bulls-eye should
appear to rest on the top of the front sight (Fig. 7).
9. When you are sure of your target and backstop, and the area around the target is clear:
a. Take the AIRSOFT GUN “OFF SAFE” (section 3A)
b. Aim
c. Pull the trigger to fire
B. ADJUSTING THE SIGHTS
1. Front sight is not adjustable
2. To change the peep sight, rotate sight forward or backward to choose the larger aperture or smaller
aperture. (Fig. 8)
9. Maintain Your Airsoft gun
1. DO NOT use petroleum distillate based oil or solvent and DO NOT over-oil as this can cause damage to
your AIRSOFT GUN.
2. DO NOT MODIFY OR ALTER YOUR AIRSOFT GUN. Attempts to modify the AIRSOFT GUN in any way incon-
sistent with this manual may make your AIRSOFT GUN unsafe to use, cause serious injury, especially to
the eye, and will void the warranty.
3. If you drop your AIRSOFT GUN, visually check to see that it works properly before you use it again.
4. If anything seems changed, like a shorter or weaker trigger pull, this may mean worn out or broken
parts. Call Crosman customer service for assistance before using your AIRSOFT GUN again.
5. To clean the AIRSOFT GUN barrel
a. Spray a cleaning patch with Crosman Nitro Lubricant oil
b. With the cleaning patch on the rod, insert it into the barrel to clean
c. Swab the barrel 3-4 times
d. Repeat the swabbing procedure with a dry patch
Fig. 3
K
Fig. 4
Load Reservoir Here
Door
18 Shot Clip
BB Guide
Fig. 5
Tip & Shake to Load
Fig. 6
Fig. 7
e. The barrel is clean when the patches come out clean after dry swabbing
10. Clearing a Jam
1. Make sure the AIRSOFT GUN is “ON SAFE” and pointed in a SAFE DIRECTION
2. Locate the Magazine (K).
3. Press the magazine release button to release the magazine.
4. If there is a BB in the barrel, use a cleaning rod (not included) to remove the BB
a. Insert the tapered end of the cleaning rod into the muzzle and CAREFULLY and slowly apply pressure
until the BB exits the barrel.
IMPORTANT: Never use sharp metal tools to remove BBs from the gun.
SPECIFICATIONS
Mechanism/Action Spring Air Repeater Velocity Up to 300 fps
Caliber/Ammunition 6mm Plastic BBs Safety Lever
Magazine Up to 400 6mm BBs
PERFORMANCE
Your AIRSOFT GUN was designed to function best with Crosman ® branded ammunition. Using other than Crosman branded ammunition may cause your product to malfunction and may
void your warranty. For optimum performance use Crosman ammunition only.
DO NOT RETURN THIS PRODUCT TO THE STORE.
Our customer service representatives are here to help you. Contact us directly at 1-800-7AIRGUN (1-800-724-7486). You can also get answers to frequently asked questions at
www.crosman.com.
CUSTOMER SERVICE
If your AIRSOFT GUN is not functioning, we recommend that you call Crosman Corporation Customer service at 1-800- 724-7486 or 585-657-6161. (International customers should
contact their distributor.) DO NOT ATTEMPT TO DISASSEMBLE IT! Crosman assumes no warranty responsibility if the gun has been disassembled.
LIMITED 30 DAY WARRANTY
This product is warranted to the retail consumer for 30 days from date of retail purchase against defects in material and workmanship and is transferable.
WHAT IS COVERED
Replacement parts and labor. Transportation charges to consumer for repaired product.
WHAT IS NOT COVERED
Transportation charges to Crosman for product. Damages caused by abuse, modification or failure to perform normal maintenance. Any other expense. CONSEQUENTIAL DAMAGES,
INCIDENTAL DAMAGES, OR INCIDENTAL EXPENSES, INCLUDING DAMAGE TO PROPERTY. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL
DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU.
HOW TO OBTAIN WARRANTY PERFORMANCE
WARRANTY CLAIMS
USA Customers: Attach your name, address, description of problem, phone number and copy of sales receipt to product. Package and return to Crosman Corporation, Routes 5 & 20,
Bloomfield, NY 14469.
International Customers: Please return product to your nearest distributor. If you do not know your distributor, please call 585-657-6161 and ask for our International Department
for assistance.
IMPLIED WARRANTIES
ANY IMPLIED WARRANTIES, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO 30 DAYS FROM DATE OF
RETAIL PURCHASE. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITATIONS MAY NOT APPLY TO YOU.
To the extent any provision of this warranty is prohibited by federal, state, or municipal law which cannot be preempted, it shall not be applicable. This warranty gives you specific legal
rights, and you may also have other rights which vary from state to state.
CROSMAN, DUTY CALLS, and GAME FACE are registered trademarks of Crosman Corporation in the United States.
Fig. 8