Crosman SAPR75 - Manual

Crosman Pulse R75
Model SAPR75 Airsoft Gun
6mm Plastic BB
OWNER’S MANUAL
Distributed by
Crosman Corporation
7629 Routes 5 & 20
Bloomfield, NY 14469
www.crosman.com
1-800-724-7486
Made in China SAPR75A515
WARNING:
This is not a toy. Adult supervision is required. Misuse may cause serious
injury, especially to the eye. Eye protection designed for airsoft guns must be worn by the
user and any person in range. May be dangerous up to 100 yds. Read the owner’s manual
before using.
WARNING:
Do not brandish or display this airsoft gun in public – it may confuse people
and may be a crime. Police and others may think it is a firearm. Do not change the coloration
and markings to make it look more like a firearm. That is dangerous and may be a crime.
NOTE: Charge the battery a MINIMUM of 4 hours and a MAXIMUM of 6 hours prior to initial use. This airsoft gun
will not operate properly without a fully charged battery. DO NOT OVERCHARGE THE BATTERY. UNPLUG THE
BATTERY CHARGER WHEN NOT IN USE.
READ ALL INSTRUCTIONS AND WARNINGS IN THIS MANUAL BEFORE USING THIS AIRSOFT GUN.
BUYER AND USER HAVE THE DUTY TO OBEY ALL LAWS ABOUT THE USE AND OWNERSHIP OF THIS AIR-
SOFT GUN.
Recommend 18 years or older to purchase. Intended for use by those 16 or older.
Please read this owner’s manual completely. Remember to treat this airsoft gun with the same respect you would a
firearm. Always carefully follow the safety instructions found in this owner’s manual and keep this manual in a safe
place for future use.
If you have any questions regarding your new airsoft gun, please contact Crosman Customer Service at: 1-800-724-
7486, 585-657-6161 or www.crosman.com.
1. Learning the Parts of Your New Airsoft Gun
Learning the names of the parts of your new airsoft gun will help you to understand your owner’s manual. Use this
manual to increase your enjoyment of this airsoft gun.
Muzzle A.
Front Sight B.
Hopper C.
Stock D.
Trigger E.
Trigger Guard F.
Battery G.
Butt Release lever H.
Hopper guide rail I.
Safety (see Fig. 2) J.
2. Operating the Safety
A. To put the airsoft gun “ON SAFE”
Locate the safety on the right side of the airsoft gun. •
Push the safety forward toward the “S” for “ON SAFE. (Fig 2A). The safety is not “ON SAFE” unless it is pushed •
all the way forward toward the “S”.
WARNING: Keep the airsoft gun in the “ON SAFE” position until you are actually ready
to shoot. Then turn the safety to the “OFF SAFE” position.
Like all mechanical devices, an airsoft gun
safety can fail. Even when the safety is
“ON SAFE”, you should continue to handle
the airsoft gun safely. NEVER point the
Airsoft gun at any person. NEVER point
the airsoft gun at anything you do not
intend to shoot.
B. To Take the Airsoft Gun “OFF SAFE”
Locate the safety on the right side of •
the airsoft gun.
Push the safety rearward toward the •
“F” for fire for “OFF SAFE”. (Fig 2B). The safety is “OFF SAFE” when it is
pushed all the way back toward the “F” positions, and can be fired.
3. Loading and Unloading Plastic BBs
NOTE: For optimum performance Crosman recommends using only Crosman
brand BBs.
A. Installing and Filling the Hopper- Loading Chamber.
Make sure the airsoft gun is “ON SAFE” (section 2A) and pointed in a SAFE •
DIRECTION.
With the gun held as shown, slide the hopper groove over the guide rail •
and push into place.
Slide the hopper door open by pushing it over to the left with your thumb. •
Fill the hopper with 6mm BBs. •
Close the hopper door. •
WARNING: Use 6 mm plastic BBs only in this airsoft gun. Use of any other ammunition
can cause injury to you or damage to the airsoft gun.
B. Removing Hopper/Unloading Plastic BBs
Make sure the airsoft gun is “ON SAFE” (section 2A). •
Point the airsoft gun in a SAFE DIRECTION. •
Slide the hopper forward, releasing it from the locked position. Slide off the gun. •
NOTE: If BBs remain in the hopper, they may fall out when removing the hopper.
Point the airsoft gun in a SAFE DIRECTION, take “OFF SAFE” and fire the gun in a safe direction until no more •
BBs fire.
Put the airsoft gun back “ON SAFE”. •
WARNING:
Never assume that because the airsoft gun no longer fires a BB and/or the
loading chamber is removed, that a BB is not lodged in the barrel. Always treat the airsoft
gun as though it is loaded and with the same respect you would a firearm.
4. Selecting the Firing Mode
NOTE: This airsoft gun fires in semi-auto or full auto mode. Full-auto means
it will continue to fire plastic BBs as long as you hold the trigger. Semi-auto
means that you will have to pull the trigger each time you want to fire a shot.
Make sure the airsoft gun is “ON SAFE” (section 2A) and pointed in a SAFE •
DIRECTION.
Locate the firing selection dial on the left side of the gun. •
Turn the dial up toward semi for “Semi-auto.” •
Turn the dial down toward full for “Full-auto.” •
5. Charging, Loading and Removing the Battery
A. Charging the Battery
NOTE: The battery charging time is a MINIMUM of 4 hours and a Maximum of 6 hours
prior to initial use. Continuous battery consumption will allow the airsoft gun to shoot
for 10-12 minutes. To prolong battery life and maintain the best shooting performance
do not shoot over 5 minutes continuously in the Full Auto Mode. DO NOT OVER-
CHARGE THE BATTERY. UNPLUG THE BATTERY CHARGER WHEN NOT IN USE.
Continuous battery consumption will allow the airsoft gun to shoot for 10-12 minutes.
To prolong battery life and maintain the best shooting performance do not shoot over
5 minutes continuously in the Full Auto Mode. For optimum performance com-
pletely use up the battery before recharging.
Plug the charger into the battery. •
Plug the charger into a standard 110v outlet. •
B. Loading the Battery
Make sure the airsoft gun is “ON SAFE” (section 2A) and is UNLOADED. •
Point the airsoft gun in a SAFE DIRECTION. •
Remove the butt of the stock by pushing up on the release and pulling the •
butt off.
Plug the battery into the battery connector. •
Insert the battery into the gun. •
Replace the butt. •
C. Removing the Battery
Make sure the airsoft gun is “ON SAFE” (section 2A) and is UNLOADED. •
Point the airsoft gun in a SAFE DIRECTION. •
Remove the butt of the stock by pushing up on the release and pulling the butt off. •
Unplug the battery from the battery connector. •
Replace the butt. •
6. Using the Hop-Up Mode
Your airsoft gun is manufactured with a hop up system. The purpose of this
system is to change the spin on the BB as it leaves the muzzle, allowing you to
adapt your shot for different distances.
Slide the Hop-up adjustment switch backward to “On” for more spin. •
Push the Hop-Up adjustment switch (Fig.) forward to “Off” for less spin. •
7. Aiming and Firing Safely
Aiming and Firing Safely
You and others with you should always wear eye protection designed for •
airsoft to protect your eyes.
Always point your airsoft gun in a SAFE DIRECTION. •
Do not shoot at hard surfaces or at the surface of water. The plastic BBs •
may bounce off or ricochet and hit someone or something you had not intended to hit.
DO NOT re-use plastic BBs because they could possibly cause damage to your airsoft gun. •
Your airsoft gun is designed for target shooting and is suited for both indoor and outdoor use. Always remember •
to place your target carefully. THINK about what you will hit if you miss the target.
When you are sure of your target and backstop, and the area around the target is clear, load and charge the air- •
soft gun following sections 3 and 4. Take the airsoft gun “OFF SAFE” (section 2A) aim and pull the trigger to fire.
8. Maintaining Your Airsoft Gun
DO NOT MODIFY OR ALTER YOUR AIRSOFT GUN. Tampering with the airsoft gun or attempts to change the •
airsoft gun in any way may make it unsafe to use, may cause serious injury or death and will void the warranty.
If you drop your airsoft gun, visually check to see that it works properly before you use it again. If anything •
seems changed, like a shorter or weaker trigger pull, this may mean parts are worn out or broken. Call Cus-
tomer Service at Crosman for assistance before using your airsoft gun again.
9. Reviewing Safety
Do not ever point the airsoft gun at any person. Do not ever point the Airsoft gun at anything you do not intend •
to shoot.
Always treat the airsoft gun as though it is loaded and with the same respect you would a firearm. •
Always aim in a SAFE DIRECTION. Always keep the muzzle of the Airsoft gun pointed in a SAFE DIRECTION. •
Always keep the airsoft gun “ON SAFE” until you are ready to shoot in a SAFE DIRECTION. •
Always check to see if the airsoft gun is “ON SAFE” and unloaded when getting it from another person or from •
storage.
Always keep your finger off the trigger and out of the trigger guard until ready to shoot. •
You and others with you should always wear eye protection to protect your eyes. •
Always wear eye protection designed for airsoft over your regular glasses. •
Use 6 mm plastic BBs only. •
Do not reuse plastic BBs because they could cause possible damage to your airsoft gun. •
Do not shoot at hard surfaces or at the surface of water. The plastic BBs may bounce off or ricochet and hit •
someone or something you had not intended to hit.
Replace the backstop if it becomes worn. Place the backstop in a location that will be safe should the backstop •
fail.
Your backstop should be checked for wear before and after each use. All backstops are subject to wear and •
will eventually fail. Replace your backstop if the surface is worn or damaged or if a ricochet occurs.
Do not attempt to disassemble or tamper with your airsoft gun. •
DO NOT MODIFY OR ALTER YOUR AIRSOFT GUN. Attempts to modify the airsoft gun in any way may make •
your airsoft gun unsafe to use, cause serious injury or death and will void the warranty.
Using unauthorized repair centers or modifying the function of your airsoft gun in any way may be unsafe and •
will void your warranty.
Do not put the airsoft gun away loaded. Make sure ALL of the plastic BBs are unloaded from the airsoft gun. •
Always store this airsoft gun in a secure location. •
SPECIFICATIONS
Mechanism/Action Electronic
Caliber/Ammunition 6mm Plastic BBs
Magazine Up to 500 6 mm BBs
Safety Lever
Velocity Up to 300 fps
PERFORMANCE: Many factors can affect velocity, including brand of projectile, type of projectile and barrel condi-
tion.
Your airsoft gun was designed to work with Crosman branded ammunition. Use of other ammunition may cause
your gun to malfunction.
DO NOT RETURN THIS PRODUCT TO THE STORE.
Our customer service representatives will help. You can get answers to frequently asked questions at www.crosman.
com or you can contact us directly at 1-800-7AIRGUN (1-800-724-7486)
CUSTOMER SERVICE
If your airsoft gun is not functioning, we recommend that you call Crosman Corporation Customer service at 1-800-
724-7486 or 585-657-6161. (International customers should contact their distributor.) DO NOT ATTEMPT TO
DISASSEMBLE IT! If you take it apart you probably will not be able to reassemble it correctly. Crosman assumes no
warranty responsibility under such circumstances.
For optimum performance use Crosman ammunition only. Using other than Crosman branded ammunition may
cause your product to malfunction and may void your warranty.
LIMITED 30 DAY WARRANTY
This product is warranted to the retail consumer for 30 days from date of retail purchase against defects in material
and workmanship and is transferable.
WHAT IS COVERED
Replacement parts and labor. Transportation charges to consumer for repaired product.
WHAT IS NOT COVERED
Transportation charges to Crosman for product. Damages caused by abuse, modification or failure to perform nor-
mal maintenance. Any other expense. CONSEQUENTIAL DAMAGES, INCIDENTAL DAMAGES, OR INCIDENTAL
EXPENSES, INCLUDING DAMAGE TO PROPERTY. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITA-
TION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT
APPLY TO YOU.
WARRANTY CLAIMS
USA Customers: Attach your name, address, description of problem, phone number and copy of sales receipt to
product. Package and return to Crosman Corporation, Routes 5 & 20, East Bloomfield, NY 14443.
International Customers: Please return product to your nearest distributor. If you do not know your distributor,
please call 585-657-6161 and ask for our International Department for assistance.
IMPLIED WARRANTIES
ANY IMPLIED WARRANTIES, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO 30 DAYS FROM DATE OF RETAIL PURCHASE.
SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE
LIMITATIONS MAY NOT APPLY TO YOU.
To the extent any provision of this warranty is prohibited by federal, state, or municipal law which cannot be pre-
empted, it shall not be applicable. This warranty gives you specific legal rights, and you may also have other rights
which vary from state to state.
CROSMAN is a registered trademark of Crosman Corporation in the United States.