Crosman S32PC - Manual

S32PC
Crosman Pump Shotgun With Adjustable Stock
6mm Plastic BBs
OWNER’S MANUAL
READ ALL INSTRUCTIONS AND WARNINGS IN THIS MANUAL BEFORE USING THIS AIRSOFT GUN
Distributed by:
Crosman Corporation
7629 Routes 5 & 20,
Bloomfield, NY 14469
United States of America
www.crosman.com
1-800-724-7486
Made in the United States of America with some foreign components. S32PC-515
This is not a toy. Adult supervision is required. Misuse may cause serious injury, especially
to the eye. Eye protection designed for airsoft guns must be worn by the user and any person in range. May
be dangerous up to 100 yards (91.44 meters). Read the owner’s manual before using.
Do not brandish or display this airsoft gun in public – it may confuse people and may be a
crime. Police and others may think it is a firearm. Do not change the coloration and markings to make it look
more like a firearm. That is dangerous and may be a crime.
This product contains a chemical known to the state of California to cause cancer and
birth defects (and other reproductive harms).
YOU AND OTHERS WITH YOU SHOULD ALWAYS WEAR EYE PROTECTION TO PROTECT YOUR EYES.
READ ALL INSTRUCTIONS AND WARNINGS IN THIS MANUAL BEFORE USING THIS AIRSOFT GUN. BUYER
AND USER HAVE THE DUTY TO OBEY ALL LAWS ABOUT THE USE AND OWNERSHIP OF THIS AIRSOFT GUN.
Recommend 18 years or older to purchase. Intended for use by those 16 or older.
Please read this owner’s manual completely. Remember to treat this airsoft gun with the same respect you would a
firearm. Always carefully follow the safety instructions found in this owner’s manual and keep this manual in a safe
place for future use.
If you have any questions regarding your new airsoft gun, please contact Crosman Customer Service at: 1-800-
724-7486, 585-657-6161 or www.crosman.com.
1. Learning the Parts of Your New Airsoft Gun
Learning the names of the parts of your new airsoft gun will help you to understand your owner’s manual. Use this
manual to increase your enjoyment of this airsoft gun.
A. Stock
B. Hop Up Adjuster
C. Muzzle
D. Forearm
E. Magazine
F. Magazine Release
G. Trigger
H. Safety (Fig. 2)
2. Operating the Safety
Keep the airsoft gun in the “ON SAFE” position until you are ready to shoot. Then turn the safety to the “OFF SAFE”
position.
2.1 Put the airsoft gun “ON SAFE:”
• Locate the safety directly behind the trigger.
• Push the safety from the left side all the way in (Fig. 2). The
safety is not “ON SAFE” unless it is pushed all the way in and
the RED ring around the left side of the safety is NOT showing.
Like all mechanical devices, a airsoft gun safety can fail. Even when
the safety is “ON SAFE”, you should continue to handle the airsoft
gun safely. NEVER point the airsoft gun at any person. NEVER point
the airsoft gun at anything you do not intend to shoot.
2.2. Take the airsoft gun “OFF SAFE”:
• Push the safety from the right side all the way in. When you can
see the RED ring around the left side of the safety, the airgun is
“OFF SAFE” and can be fired.
3. Loading and Unloading Plastic BBs
3.1 Loading Plastic BBs
• Make sure the soft air rifle is “ON SAFE” (See Step 2.1).
• Point the soft air rifle in a SAFE DIRECTION.
• Release the BB magazine by pushing in on the magazine release button behind
the magazine (Fig. 3).
• Flip open the door on top of the magazine.
• Pour up to 491 plastic BBs in to the magazine.
• Close the BB loading door.
• Turn the magazine as shown in Figure 3 and pull back the BB follower tab.
• Gently shake the magazine, allowing BBs to load in the chamber. Fig. 4A and
4B.
• Place a finger over the end of the magazine where the BBs will exit.
• With the magazine pointed in a safe direction, release the BB Follower tab.
NOTE: Releasing the BB follower tab quickly, or without the end covered, could
allow BBs to exit the magazine.
• Insert the loaded clip into the airsoft gun.
• Your airsoft gun is now loaded and ready to fire, after reading the entire
manual.
3.2 Unloading Plastic BBs
• Make sure the airsoft rifle is “ON SAFE” and pointed in a SAFE DIRECTION.
• Release the BB magazine by pushing in on the magazine release button
behind the magazine (Fig. 3).
• Do not put the clip back in the gun.
• Follow section 5 on pumping the airsoft gun.
• After reading Section 7 on aiming and firing safely, take the gun ”OFF SAFE”
and pull the trigger.
• Repeat these steps until you are no longer firing plastic BBs.
• Put the airsoft gun back “ON SAFE”.
• Open the BB loading door of the magazine and pour out any remaining – 6mm airsoft BBs into a clean con-
tainer.
• Close the BB loading door.
4. Pumping Your Airsoft Rifle
• Put the airsoft gun “ON SAFE” (See Step 2.1).
Always hold the forearm firmly when you pump it to prevent possible injury.
Never pump your airsoft gun more than once. Over-pumping can cause major damage to your
airsoft gun.
• Holding the forearm firmly, pull it all the way back. Do not twist the forearm while pumping. Use a straight
stroke to prevent breakage (Fig. 5).
• Return the forearm to the original closed position with a smooth
stroke. Be sure to hold the forearm firmly as you close it.
NOTE: You must follow the procedure for pumping and firing your
airsoft gun each time you shoot.
5. Adjusting the Hop Up
Your airsoft gun is manufactured with a hop-up system. The purpose
of this system is to change the spin on the BB as it leaves the muzzle
allowing you to adapt your shot for different distances.
• Make sure the airsoft gun is “ON SAFE” (see section 2A) and
the magazine is removed.
• Point the airsoft gun in a SAFE DIRECTION.
• Locate the hop up adjustment slide on the side of the gun
(fig. 6) Push the slide back for less spin or forward for more
spin.
6. Aiming and Firing Safely
6.1 Aiming Safely
• You and others with you should always wear shooting
glasses to protect your eyes.
• Always aim your airsoft rifle in a SAFE DIRECTION. When
you are sure of your target and backstop, and the area around the target is clear, pump the airsoft rifle (See
Step 4), take “OFF SAFE” (See Step 2.2) and squeeze the trigger to fire.
• Do not shoot at hard surfaces or at the surface of water. The plastic BBs may bounce off or ricochet and hit
someone or something you had not intended to hit. If the plastic BBs should happen to hit a hard surface, DO
NOT reuse those plastic BBs because they could cause possible damage to your airsoft rifle.. 6
• Always choose your target carefully. It is best to shoot at targets, which are attached to a safe backstop. Your
backstop should be checked for wear before and after each use. Replace your backstop if the surface is worn
or damaged, or if a ricochet occurs.
• Your airsoft rifle is designed for target shooting and is suited for both indoor and outdoor use. Always remem-
ber to place your target carefully. THINK about what you will hit if you miss the target, or if the plastic BB
richochets.
6.2 Firing Safely
• Make sure the airsoft rifle is “ON SAFE” (See Step 2.1).
• Point the airsoft rifle in a SAFE DIRECTION.
Fig. 2
Magazine
Release Fig. 3
Fig. 4A
Fig. 4B
Fig. 5
Fig. 6
• Follow section 5 on pumping the airsoft gun.
• After reading section 7 on aiming and firing safely, take the airsoft gun “OFF SAFE” and pull the trigger.
• Repeat these steps until you are no longer firing plastic BBs.
• Put the airsoft gun back “ON SAFE”.
• Remove the magazine.
7. Maintaining Your Airsoft Rifle
• Tampering with the airsoft rifle or attempts to change the airsoft rifle in any way may make it unsafe to use,
cause injury particularly to the eye, and will void the warranty.
• If you drop your airsoft rifle, check to see that it works properly before you use it again. If anything seems
changed, like a shorter or weaker trigger pull, this may mean worn out or broken parts. Call Customer Service
at Crosman for assistance before using your airsoft rifle again.
8. ADJUSTING THE STOCK
• The airsoft gun is shipped with the stock in the closed position and is capable of adjusting to different lengths.
• Before adjusting the stock make sure the airsoft gun is “ON SAFE”, (see section 2A) and pointed in a SAFE
DIRECTION.
• Push the stock release lever and adjust the stock until it locks into the desired position.
9. Reviewing Safety
• Do not ever point the airsoft rifle at any person. Do not ever point the airsoft rifle at anything you do not intend
to shoot.
• Always treat the airsoft rifle as though it is loaded and with the same respect you would a firearm.
• Always aim in a SAFE DIRECTION. Always keep the muzzle of the airsoft rifle pointed in a SAFE DIRECTION.
• Always keep the airsoft rifle “ON SAFE” until you are ready to shoot in a SAFE DIRECTION.
• Always check to see if the airsoft rifle is “ON SAFE” and unloaded when getting it from another person or from
storage.
• Always keep your finger off the trigger and out of the trigger guard until ready to shoot.
• If your reading or prescription glasses are not safety glasses make sure you wear shooting glasses over your
regular glasses.
• Use 6 mm plastic BBs only.
• Do not shoot at hard surfaces or at the surface of water. The plastic BBs may bounce off or ricochet and hit
someone or something you had not intended to hit. If the plastic BBs should happen to hit a hard surface, DO
NOT reuse those plastic BBs because they could cause possible damage to your airsoft rifle.
• Replace the backstop if it becomes worn. Place the backstop in a location that will be safe should the back-
stop fail.
• Do not attempt to disassemble or tamper with your airsoft rifle. Call Customer Service at Crosman Corporation
for repair.
• Do not put the airsoft rifle away loaded. Make sure ALL of the plastic BBs are unloaded from the airsoft rifle
(See Step 3.2).
• Always store this airsoft rifle in a secure location.
SPECIFICATIONS
Mechanism/Action Single shot spring pump
Overall length Up to 26.5 in. (67.31 cm)
Caliber/Ammunition 6mm plastic BBs
Safety Cross bolt
Magazine Capacity Adjustable model Up to 24 plastic BBs
Velocity Up to 350 fps (106.7 m/s)
Reservoir Adjustable model Up to 491 plastic BBs
Weight 2.98 lbs. (1.35 kg)
Barrel Material Smooth bore aluminum
PERFORMANCE: Many factors can affect velocity, including brand of projectile, type of projectile and barrel condition.
DO NOT RETURN THIS PRODUCT TO THE STORE.
Our friendly customer service representatives will be glad to help. You can get answers to frequently asked
questions at www.crosman.com or you can contact us directly at 1-800-7AIRGUN (1-800-724-7486)
CUSTOMER SERVICE
If your airsoft gun is not functioning, we recommend that you call Crosman Corporation Customer service at 1-800-
724-7486 or 585-657-6161. (International customers should contact their distributor.) DO NOT ATTEMPT TO
DISASSEMBLE IT! If you take it apart you probably will not be able to reassemble it correctly. Crosman assumes no
warranty responsibility under such circumstances.
For optimum performance use Crosman ammunition only. These include CROSMAN, COPPERHEAD, and
BENJAMIN.
Using other than Crosman branded ammunition may cause your product to malfunction and may void your warranty.
LIMITED 30 DAY WARRANTY
This product is warranted to the retail consumer for 30 days from date of retail purchase against defects in material
and workmanship and is transferable.
WHAT IS COVERED
Replacement parts and labor. Transportation charges to consumer for repaired product.
WHAT IS NOT COVERED
Transportation charges to Crosman for product. Damages caused by abuse, modification or failure to perform
normal maintenance. Any other expense. CONSEQUENTIAL DAMAGES, INCIDENTAL DAMAGES, OR INCIDEN-
TAL EXPENSES, INCLUDING DAMAGE TO PROPERTY. SOME STATES DO NOT ALLOW THE EXCLUSION OR
LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION
MAY NOT APPLY TO YOU.
WARRANTY CLAIMS
USA Customers: Attach your name, address, description of problem, phone number and copy of sales receipt to
product. Package and return to Crosman Corporation, Routes 5 & 20, Bloomfield, NY 14469.
International Customers: Please return product to your nearest distributor. If you do not know your distributor,
please call 585-657-6161 and ask for our International Department for assistance.
IMPLIED WARRANTIES
ANY IMPLIED WARRANTIES, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO 30 DAYS FROM DATE OF RETAIL PURCHASE.
SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE
ABOVE LIMITATIONS MAY NOT APPLY TO YOU.
To the extent any provision of this warranty is prohibited by federal, state, or municipal law which cannot be pre-
empted, it shall not be applicable. This warranty gives you specific legal rights, and you may also have other rights
which vary from state to state.
CROSMAN is a registered trademark of Crosman Corporation in the United States.