Casio XJ-S36 EN - Manual (Page 15)

E-15
Getting Ready
Eng
lish
Note that the condition of the environment where you use the projector greatly affects its
performance. Make sure that the following are the conditions of projector setup whenever you
use it.
z Use a conveniently located power outlet that you can reach easily when you need to unplug
the projector.
z Do not place any objects within the area indicated by the dashed line in the illustration
below. Be especially careful that you never block intake and exhaust vents.
z Do not locate any objects near the projector while it is in use. Keep all items at least 30cm
(11.8 inches) away from the intake and exhaust vents.
z The vents become quite hot while the projector is in use. Never touch the vents with your
hands. Also, the areas near the exhaust vents become quite hot. Never locate objects made
of plastic or other heat-sensitive materials near or under the projector. Doing so creates the
risk of deformation and discoloration of the object.
z Avoid placing the projector on a surface that is unstable or prone to vibration. Never place
the projector on top of a carpet, blanket, towel, or other soft material.
z Do not locate the projector where it will be exposed to direct sunlight.
z Avoid locations where there are large amounts of dust and moisture.
z Keep the projector away from speakers, TVs, radios, and other devices that generate
magnetism, as well as from heaters.
z Over time, use of the projector can cause dust and dirt to build up in and around the fan’s
intake vents, which can lead to malfunction of the projector. Be sure to check the intake
vents for dust build up each time before you use the projector. If you see dirt or dust in or
around the intake vents, remove it by wiping with a cloth, etc.
z When positioning the projector, make sure you do so in such a way that the intake vents do
not become blocked. Blocked intake vents can shorten the life of the lamp.
z Airflow from air conditioning equipment can blow the heat being exhausted from the area
around the projector’s lens in a way that causes heat ripples to appear in the projected
image. If this happens, adjust the airflow of the air conditioning equipment or move the
projector.
Setup Precautions
30 cm
(11.8 inches)
Intake vents
Allow sufficient clearance and do
not block intake and exhaust vents.
Intake vents
Exhaust vents