Comtrol VS2000 V.34 User Manual
Page 4
6.
No repairs are to be made by you. Repairs are to be
made only by Comtrol or its licensees.
Unauthorized repairs void the warranty and the
registration.
7.
This equipment cannot be used for public coin
service provided by the telephone company.
Connection to Party Line Service is subject to state
tariffs. (Contact the state public utility commission,
public service commission, or corporation
commission for information.)
VS2000 - Canada
The VS2000 connects directly to off-premises Common
Carrier facilities using the standard two-wire telephone
connection. In some cases, the building’s inside wiring
associated with a single line individual server may be
extended by means of a certified connector assembly
(telephone extension card).
NOTICE: The Industry Canada label identifies certified
equipment. This certification means the equipment
meets telecommunications network protective,
operational, and safety requirements as prescribed in the
appropriate Terminal Equipment Technical
Requirements document(s). The Department does not
guarantee the equipment will operate to the user’s
satisfaction.
Before installing this equipment, users should ensure
that it is permissible to be connected to the facilities of
the local telecommunications company. The equipment
must also be installed using an acceptable method of
connection. The customer should be aware that
compliance with the above conditions may not prevent
degradation of service in some situations.
Repairs to certified equipment should be coordinated by
a representative designated by the supplier. Any
repairs or alterations made by the user to this
equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user
to disconnect the equipment.
Users should ensure for their own protection that the
electrical ground connections of the power utility,
telephone lines, and internal metallic water pipe
system, if present, are connected together. This
precaution may be particularly important in rural areas.
CAUTION: Users should not attempt to make such
connections themselves, but should contact the
appropriate electric inspection authority or electrician,
as appropriate.
NOTICE: The Ringer Equivalence Number (REN)
assigned to each terminal device provides an indication
of the maximum number of terminals allowed to be
connected to a telephone interface. The termination on
an interface may consist of any combination of devices,
subject only to the requirement that the sum of the
Ringer Equivalence Numbers of all the devices does not
exceed 5.
This digital apparatus meets the Class A limits for radio
noise for digital apparatus set out in the interference-
causing equipment standard entitled: “Digital
Apparatus,” ICES-003 of Industry Canada.
When connecting the VS2000 to the telephone service,
avoid contact with the telecommunications lead wire.
Grasp the insulated part of the jack, and do not contact
the back of the circuit board. Telephone wiring can carry
dangerous voltages from electrical faults or lightning.
External Wiring
Any external communications wiring you may install
needs to be constructed to all relevant electrical codes.
In the United States this is the National Electrical Code
Article 800. Contact a licensed electrician for details.
Canada - Return Center
In Canada, contact the following Return Center:
Gandacar Consulting, Ltd
189 Lake Avenue East
Carlton Place, Ontario
Canada K7C 1J7 Phone: 800-563-5102
Technical Support
If you need technical support, contact Comtrol using one
of the following methods.
•
FAX
: (651) 631-8117
• Phone: (651) 631-7654
•
FTP
Site: ftp://ftp.comtrol.com
•
Comtrol has a staff of technical support representatives
to help you.
First Edition, July 7, 1998
Copyright © 1998. Comtrol Corporation.
All Rights Reserved.
Comtrol Corporation makes no representations or
warranties with regard to the contents of this document
or to the suitability of the Comtrol product for any
particular purpose. Specifications subject to change
without notice. Some software or features may not be
available at the time of publication. Contact your
reseller for current product information.
Trademark Notices
Comtrol, InterChangeVS, and VS-Link are trademarks
of Comtrol Corporation.
Other product names mentioned herein may be
trademarks and/or registered trademarks of their
respective owners.
6631